Titan Electronics Inc NETCOM423 ユーザーズマニュアル

The basic parameters “IP address” and “Netmask” are mandatory. If 
any of these is changed, the NetCom Manager  calculates  a  matching 
address for “Broadcast”. You may also change this address. 
The DHCP option will also configure the “Default gateway” and the 
“Name server”. Without DHCP you must enter these parameters by 
yourself. However they are not required in all configurations. So enter 
0.0.0.0 if they are not used. 

 

 

Image 53: NetCom Manager Ports Panel 

The “Ports” panel lists all serial ports of a NetCom. Some of the options 
are driver related, e.g. the “Com Number”. Each serial port may operate 
via three TCP ports. The “TCP Control Port” is used in the Virtual Com 
Driver mode, and also in Null-Modem Tunnel. If Driver mode is not 
desired, this parameter is ignored almost always. 
The “TCP Data Port” is used to transmit data to and from the serial 
port. Use the default, or change the value to the settings required for 
your network. There is also a “UDP Data Port”, used in packet data 
transfer. You can not switch the NetCom to UDP mode with the 
Manager. But if it is already in this mode, you can change this basic 
parameter. 

823RM WLAN, 1623RM WLAN  

Page 

46