Yaesu Musen Co. Ltd. 20485X40 ユーザーズマニュアル
17
Before Using
Connecting the Radio
Connecting the controller to the main body
Caution
Make sure the power supply is switched OFF before connecting the cable between the controller and
the main body.
the main body.
1
Plug the connector of the controller cable into the
[CONTROL] jack at the front of the main body
until a click sound is heard
until a click sound is heard
Main
body
Controller
cable
2
Plug the other connector of the controller cable
into the [CONTROL] jack at the back of the
controller until a click sound is heard
controller until a click sound is heard
Controller cable
Controller
Connecting the microphone
1
Plug the microphone connector into the [MIC]
jack at the front of the main body until a click
sound is heard
sound is heard
Tips
• To remove the microphone, pull the connector out
while pressing the latch.
• Using the optional microphone extension kit “MEK-
2”, a microphone with a 8-pin connector can be
used. A microphone extension cable (about 3 m
long) is also included in MEK-2. Use it to install the
microphone in locations which cannot be reached
by the attached microphone cable.
used. A microphone extension cable (about 3 m
long) is also included in MEK-2. Use it to install the
microphone in locations which cannot be reached
by the attached microphone cable.
LO
CK
P3
P2
P1
7
1
4
8
2
0
5
9
B
A
C
D
3
6
P4
LAMP
DTMF MICROPHONE
MH-48
ABC
JKL
TUV
GHI
PQRS
DEF
MNO
WXYZ
MIC
Connector
Microphone
Connecting the antenna
1
Attach the antenna co-axial cable to the [ANT]
terminal at the back of the main body and tighten
the connector
the connector
同軸ケーブル端子
本体(後面)
Main body
(rear side)
Co-axial cable connector
Application for FCC / IC
FCC ID: K6620485X40
IC: 511B-20485X40