Yaesu Musen Co. Ltd. 30043X30 ユーザーズマニュアル
GX2360S
Page 24
6.4 SIMPLEX/DUPLEX CHANNEL USE
Refer to the VHF MARINE CHANNEL CHART (page 63) for instructions on use
of simplex and duplex channels.
of simplex and duplex channels.
NOTE
All channels are factory-programmed in accordance with FCC (USA),
Industry Canada (Canada), and International regulations. Mode of op-
eration cannot be altered from simplex to duplex or vice-versa.
Industry Canada (Canada), and International regulations. Mode of op-
eration cannot be altered from simplex to duplex or vice-versa.
6.5 USA, CANADA, AND INTERNATIONAL MODE
1. To change the modes, hold the [16/9] key and press the [WX] key. The
mode changes from USA to International to Canadian with each press of
the [WX] key.
the [WX] key.
2. “USA” will be displayed on the LCD for USA mode, “INTL” will be displayed
for International mode, and “CAN” will be displayed for Canadian mode.
3. Refer to the VHF MARINE CHANNEL CHART (page 63) for allocated chan-
nels in each mode.
6.6 NOAA WEATHER CHANNELS
1. To receive a NOAA weather channel, press the [WX] key from any channel.
The transceiver will go to the last selected weather channel.
2. Turn the CHANNEL selector knob on the radio or [UP(
p)] / [DOWN(q)]
keys on the microphone to select a different NOAA weather channel.
3. To exit from the NOAA weather channels, press the [WX] key. The trans-
ceiver returns to the channel it was on prior to a weather channel.
6.7 NOAA WEATHER ALERT
In the event of extreme weather disturbances, such as storms and hurricanes,
the NOAA (National Oceanic and Atmospheric Administration) sends a weather
alert accompanied by a 1050 Hz tone and subsequent weather report on one of
the NOAA weather channels. When the Weather Alert feature is enabled (see
section 8.5 WX ALERT), the transceiver is capable of receiving this alert if the
following is performed:
1. Program NOAA weather channels into the transceiver’s memory for scan-
the NOAA (National Oceanic and Atmospheric Administration) sends a weather
alert accompanied by a 1050 Hz tone and subsequent weather report on one of
the NOAA weather channels. When the Weather Alert feature is enabled (see
section 8.5 WX ALERT), the transceiver is capable of receiving this alert if the
following is performed:
1. Program NOAA weather channels into the transceiver’s memory for scan-
ning. Follow the same procedure as for regular channels under section
6.15.
6.15.
2. Press the [SCAN] key once to start memory scanning or hold down the
[SCAN] key during memory scanning to start priority scanning.
3. The programmed NOAA weather channels will be scanned along with the
regular-programmed channels. However, scanning will not stop on a nor-
mal weather broadcast unless a NOAA alert is received.
mal weather broadcast unless a NOAA alert is received.
FCC ID: K6630043X30 / IC ID: 511B-30043X30
Vertex Standard Co., Ltd.