Yaesu Musen Co. Ltd. FT-2800M ユーザーズマニュアル
FCC ID: K66FT-2800M
OPERATING MANUAL
Vertex Standard Co., Ltd.
16
1. Press and hold the [MHz(SET)] key for one second, then rotate the DIAL knob to
select “21 RPTR”.
2. Press the [MHz(SET)] key, then rotate the DIAL knob to select the desired shift
direction (–RPTR, +RPTR, or SIMP).
3. Press and hold the [MHz(SET)] key for one second to save your new setting and exit
to normal operation.
With repeater shift activated, you can temporarily reverse the transmit and receive
frequencies by pressing the [REV(DW)] key (or microphone’s [B] key). Use this feature
to display the transmit frequency without transmitting, and to check the strength of
signals on a repeater uplink frequency (so as to determine whether or not a particular
station is within “Simplex” range, for example).
frequencies by pressing the [REV(DW)] key (or microphone’s [B] key). Use this feature
to display the transmit frequency without transmitting, and to check the strength of
signals on a repeater uplink frequency (so as to determine whether or not a particular
station is within “Simplex” range, for example).
The repeater offset is fixed to 600 kHz from the factory. You can change the offset by
following procedure, if needed:
1. Press and hold the [MHz(SET)] key for one second, then rotate the knob to select
following procedure, if needed:
1. Press and hold the [MHz(SET)] key for one second, then rotate the knob to select
“24 SHIFT”.
2. Press the [MHz(MHz)] key, then rotate the DIAL knob to set the desired offset.
Note that the resolution of the “standard” repeater shift is to the nearest 50 kHz
multiple.
multiple.
3. Press and hold the [MHz(SET)] key for one second to save your new setting and exit
to normal operation.
[2] Automatic Repeater Shift
The ARS (Automatic Repeater Shift) feature in this transceiver allows easy and
convenient repeater operation by automatically activating the repeater shift function
whenever you tune to a standard repeater sub band. The ARS function is preset at the
factory to conform to the standards for the country to which it is exported.
The ARS function is enabled at the factory. To disable it:
1. Press and hold the [MHz(SET)] key for one second, then rotate the DIAL knob to
The ARS (Automatic Repeater Shift) feature in this transceiver allows easy and
convenient repeater operation by automatically activating the repeater shift function
whenever you tune to a standard repeater sub band. The ARS function is preset at the
factory to conform to the standards for the country to which it is exported.
The ARS function is enabled at the factory. To disable it:
1. Press and hold the [MHz(SET)] key for one second, then rotate the DIAL knob to
select “02 ARS”.
2. Press the [MHz(SET)] key, then rotate the DIAL knob to change the display to
“OFF”.
3. Press and hold the [MHz(SET)] key for one second to save your new setting and exit
to normal operation.
To enable the ARS function again, select to “ON” in step 2 above.