Giant Electronics Ltd 2G4DSS24NS3 ユーザーズマニュアル
OLYMPIA OL2410 Owner's Manual
13
3 Installation and Charging of the Battery Pack
Open the battery compartment by sliding the cover down.
Plug the Battery Pack connector into the Handset battery socket. Place the
battery pack and wires in the compartment.
Close the battery compartment.
Mount the belt clip and one of the provided face panels on the Handset.
Plug the Battery Pack connector into the Handset battery socket. Place the
battery pack and wires in the compartment.
Close the battery compartment.
Mount the belt clip and one of the provided face panels on the Handset.
Choose the appropriate mounting bracket. The smaller bracket is for desk or
countertop installations. The larger bracket is for wall mounting. You must
use one of these brackets. Thread the telephone cord and DC power cord
through the large opening in the bracket. Plug the two cords into the
corresponding jacks on the bottom of the Base.
Snap the bracket into place on the back of the Base. If you are using the desk
top bracket, run the two cords through the channel at the back of the bracket.
If you are wall mounting the Base, carefully line up the slots on the wall
mount bracket with the studs on the telephone wall plate, and carefully mount
the telephone on the wall.
countertop installations. The larger bracket is for wall mounting. You must
use one of these brackets. Thread the telephone cord and DC power cord
through the large opening in the bracket. Plug the two cords into the
corresponding jacks on the bottom of the Base.
Snap the bracket into place on the back of the Base. If you are using the desk
top bracket, run the two cords through the channel at the back of the bracket.
If you are wall mounting the Base, carefully line up the slots on the wall
mount bracket with the studs on the telephone wall plate, and carefully mount
the telephone on the wall.
PDF created with FinePrint pdfFactory trial version