RELM WIRELESS CORP. - BK RADIO APV5 ユーザーズマニュアル
50
BK Radio
Priority Delay
Your dealer can set the priority delay time for
0 to 5 seconds in 0.5-second increments. This
time delay is the time from when you lose a
carrier for the priority channel and the time
the radio stays tuned to the receive frequency
of the priority channel. This is also the time
you have to transmit on the transmit
frequency of the priority channel.
0 to 5 seconds in 0.5-second increments. This
time delay is the time from when you lose a
carrier for the priority channel and the time
the radio stays tuned to the receive frequency
of the priority channel. This is also the time
you have to transmit on the transmit
frequency of the priority channel.
Priority Receiving
Priority channel receive sampling only
occurs while the radio is not transmitting.
With priority mode enabled, the radio
samples either the programmed preset
priority channel (modes B or C), the
priority channel that you selected (modes
D or E), or the position of the channel
knob (mode A) (See Table 6).
occurs while the radio is not transmitting.
With priority mode enabled, the radio
samples either the programmed preset
priority channel (modes B or C), the
priority channel that you selected (modes
D or E), or the position of the channel
knob (mode A) (See Table 6).
Priority During Scan-All-Groups Scanning
The priority channel that is sampled and all
priority mode transmitting occurs within the
group the radio was in when Scan All Groups
scanning was initiated.
priority mode transmitting occurs within the
group the radio was in when Scan All Groups
scanning was initiated.
Table 6 summarizes channel selection,
whether scanning is in manual mode, whether
the talkback scan feature is enabled, and
whether a carrier is present at the time you
press the PTT switch. This information is
only for channel selection. Other settings,
such as busy-channel lockout during active
carriers, will still determine whether actual
transmission is possible.
whether scanning is in manual mode, whether
the talkback scan feature is enabled, and
whether a carrier is present at the time you
press the PTT switch. This information is
only for channel selection. Other settings,
such as busy-channel lockout during active
carriers, will still determine whether actual
transmission is possible.