CALAMP WIRELESS NETWORKS INC. MCUC5 ユーザーズマニュアル
120 40101-100
8
Integra T Technical Manual
2.3.3.1 Connector
Pinout
For reference, the DE-9 F pinout is shown be-
low:
low:
1
2
3
4
5
6
7
8
9
Figure 9 - COM connector pin locations
2.3.4 Com
Port
Baud rates from 300 – 9600 are supported. Un-
less required by your operating protocol, we
advise restricting port speed to be equal to or
less than the RF network speed.
less required by your operating protocol, we
advise restricting port speed to be equal to or
less than the RF network speed.
Table 1: COM port signals
Pin
Name
Function
1
DCD
Output: Always asserted or asserted
when RX data available (selectable
via RSS)
when RX data available (selectable
via RSS)
2
RXD
Output: Data from Integra-To DTE
3
TXD
Input: Data from DTE to Integra
4
DTR
Input: Ignored
5
GND
Signal and chassis ground
6
DSR
Output: always positive (asserted)
7
RTS
Input: Must be asserted for unit to
accept TX data.
accept TX data.
Will “wake up” a unit in sleep mode.
Used as a “begin transmission” signal
in RTS mode.
in RTS mode.
8
CTS
Output: Used for handshaking in both
DOX and RTS modes.
DOX and RTS modes.
RTS mode: RTS/CTS delay is 4ms.
DOX mode: CTS always asserted,
except when data overflow is de-
tected.
except when data overflow is de-
tected.
9
RI
Not connected
2.3.4.1
3 Wire Connection (DOX)
The Integra-T provides and expects normal
handshaking signals, such as CTS, DCD and
DSR, for DTE using such signals. However, it
can also be operated in DOX mode (Data Oper-
ating Transmission) with only Transmit Data,
Receive Data and Ground (“3 wire interface”).
handshaking signals, such as CTS, DCD and
DSR, for DTE using such signals. However, it
can also be operated in DOX mode (Data Oper-
ating Transmission) with only Transmit Data,
Receive Data and Ground (“3 wire interface”).
1
2
3
4
5
6
7
8
9
2
3
4
5
6
7
8
9
RXD
TXD
GND
TXD
GND
DE-9M
Figure 10 - 3 wire interface
2.3.5 Setup
Port
The Setup port uses a DE-9 female connector
configured as DCE. Signals are described in the
following table.
configured as DCE. Signals are described in the
following table.
Table 2: Setup Port signals
Pin
Name
Function
1
DCD
Tied directly to DTR.
2
RXD
Data from Integra-To setup PC
3
TXD
Data from setup PC to Integra
4
DTR
Tied directly to DCD.
5
GND
Signal and chassis ground
6
DSR
Output; always positive (asserted)
7
RTS
Tied to CTS. Also monitored to “wake
up” unit from sleep mode.
up” unit from sleep mode.
8
CTS
Tied to RTS.
9
RI
not used
The Setup port uses a proprietary commun-
ications protocol designed to work with the In-
tegra RSS, RRSS and RDS programs and to
provide numeric diagnostic information.
ications protocol designed to work with the In-
tegra RSS, RRSS and RDS programs and to
provide numeric diagnostic information.