USA Alinco Branch DJ-196T ユーザーズマニュアル

ページ / 18
5  Operation 1 (Basics)
5-1 Adjusting the Volume
.  [VOL」 appears on LCD when VOL key is pressed, volume level is displayed.
The initial value is 00 (minimum).  The volume can be increased or decreased by
rotating the dial.  The maximum value is 20.
 There are 21 steps from 00-20 in volume adjustment.  The setting value can be
  kept even while the power is off.
.  When the volume point data is (00), the voice can not be heard.
 Press any key (except for FUNC, MONI key) to complete the setting.  The LCD
  returns to the ordinal mode.
 When no operation is continued for 5 seconds, the setting is completed automatically.
  Then the LCD will return to the ordinal mode.
【Operation】The volume increases as the setting value increases.
5-2 Adjusting the Squelch
 Press the SQL key, and "SQL" icon appears on the LCD.  Then the squelch level is displayed.
 The initial setting value is 00 (minimum).  The squelch level can be increased or decreased by
 rotating the dial.  This value can be kept while the power is turned OFF.
.  There are 21 steps from 00-20 in the squelch level.
.  Press any key (except for FUNC and MONI keys) to complete the setting.  Then  the  LCD
returns to the ordinal mode.
.  When no operation is continued for 5 seconds, the setting is completed automatically.  Then the
LCD will return to the ordinal mode.
【Operation】The squelch will be opened with the strong signal when the high value is set.
5-3 Receiving
1.  Turn the power SW ON.
2.  Press the VOL key to increase the volume.  Rotate the dial to set to the proper
   volume.
3.  Press and hold the SQL key, and rotate the dial until the noise disappears.
4.  Select the desired frequency.  [BUSY] appears on the LCD as soon as the signal is
   received in the desired frequency.  Then receiving voice is heard.  At the same time green RX
   indicator lights up.
5-4 Transmitting
1.  Select the desired frequency.
2.  Press the PTT key, and the red TX indicator lights up to show the unit starts transmitting.
   While pressing PTT key, speak to the internal microphone on the front of the unit
   with your normal voice.
3.  The transmission will be completed when the PTT key is released, then the unit
   returns to the receiving mode.
Note: Press and hold the PTT key, then press MONI key to transmit the tone burst.
Note: If the PTT key is pressed outside the transmission frequency range, [OFF] will
      appear on the LCD and you can not transmit.
5-5 Frequency Selection
1.  Each time the V/M key is pressed, the mode is switched between VFO mode and memory mode.
2.  VFO mode is selected by V/M key