DEI Headquarters Inc. DEI7352 ユーザーズマニュアル

ページ / 52
20
© 2011 Directed Electronics. All rights reserved.
Using the system
Active arming
You can arm the system by pressing
�������
of your trans mit ter for one
second. When the system arms, you hear a short siren sound, or chirp,
and see the parking lights flash once. If the power door locks are con-
trolled by the system, the doors also lock. While the sys tem is armed,
the status LED flashes approximately once per sec ond, indicating that
the system is actively pro tect ing your vehicle. If you hear a second chirp
after arming, and see the status LED flashing in groups, then consult the
Diagnostics Section of this guide. This extra chirp is a Bypass No ti f ca-
tion.
Passive arming
The system can be programmed to arm itself au to mat i cal ly (called pas sive
arming). If the system is programmed for passive arming, it will automati-
cally arm 30 seconds after the ignition is turned off and the system detects
that you have left the vehicle by opening and closing a door. Whenever
the system is in its 30-sec ond passive arming count down, the status LED
will flash twice as fast as it does when the system is armed. At the 20-sec-
ond point of the countdown, the siren will chirp to indicate that the system
is about to arm. At the 30-second point, the parking lights will flash to
indicate that the system is armed.
Note: If any protected entry point (such as a door or a switch-protected
trunk or hood) is open, the system will not passively arm unless forced
passive arming is programmed on. See Programming Options section.