Digital Security Controls Ltd. 00SS5501Z32 ユーザーズマニュアル

3

Enter the following at each keypad installed on the
system:

1. Enter Installer Programming by pressing

[*][8][Installer’s Code]

2. Press [000] for Keypad Programming

3. Press [0] for Partition and Slot Assignment

4. Enter a two digit number to specify the partition

and slot assignment.

1st digit

Enter 0 for Global Keypad
Enter 1 for Partition 1 Keypad
Enter 2 for Partition 2 Keypad

2nd digit

Enter 1 to 8 for Slot Assignment

5. Press the [#] key twice to exit programming.

6. After assigning all keypads, perform a supervisory

reset by entering [*][8][Installer’s Code][902]. The
panel will now supervise all assigned keypads
and enrolled modules on the system.

1. Enter [✱][8][Installer’s Code]

2. Enter [903] to display all modules. On the

LCD5501Z32-900

 keypad, 1

1

1

1

1 and 1

1

1

1

17

7

7

7

7 will scroll on

the keypad to indicate that the LCD5501Z32-900 is
present on the system. 1

1

1

1

1 designates the keypad

section, and 17

17

17

17

17 is used to show the receiver

section is also supervised. On the LCD5500Z
keypad, scroll until the module name appears on
the display.

3. To exit press [#].

If both modules do not show on the keypad, one of
the following conditions may be present:

• the keypad is not connected properly to the Keybus
• there is a problem with the Keybus wiring run

• the keypad does not have enough power