Fleetwood Group Inc N240D ユーザーズマニュアル

ページ / 7
 
 
 
 
 
¾  FCC Part 15.249:  Operation within the bands 902-928 MHz, 2400-2483.5 MHz, 5725-5875 MHz, and 
24.0-24.25 GHz. 
¾  IC RSS-210 Issue 7:  2007: Low power license-except radio-communications devices (all frequency 
bands): Category 1 equipment. 
 
1.5 FCC/IC Compliance 
This device complies with Part 15 of the FCC Rules and RSS-210 of the Industry Canada Rules.  Operation is 
subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept 
any interference, including interference that may cause undesired operation of the device.  The user is cautioned that 
changes or modifications to the device that are not approved by the manufacturer could void the user’s authority to 
operate the device. 
 
1.6 EU Compliance 
This device is a 2.4 GHz low power response system controller intended for residential and commercial use in all 
EU and EFTA member states except in Bulgaria, France, Italy, Luxembourg, Norway and Romania where restrictive 
use applies.  See table below for explanation of restrictions. 
1.7 Explanation of EU Restrictions 
 
Country: Restriction: 
Reason/remark 
Bulgaria 
 
General authorization required 
for outdoor use and public 
service. 
France 
Outdoor use limited to 10 mW 
E.I.R.P. within the band 2454-
2483.5 MHz. Derogation in 
French overseas departments of 
Guyane and La Réunion: outdoor 
use not allowed in band 2400-
2420 MHz 
Military Radiolocation and Fixed 
Service use 
Italy 
 
If used outside of own premises, 
general authorization is required. 
Luxembourg None 
General 
authorization required 
for public service 
Norway 
Implemented 
This subsection does not apply 
for the geographical area within a 
radius of 20 km from the centre 
of Ny-Alesund 
Romania 
On a secondary basis. Individual 
license required. T/R 22-06 not 
implemented 
 
 
 
Notice 
 
The module may be susceptible to Electrostatic  Discharge (ESD) and other similar fast transient events causing 
system interruption.  Should system interruption occur, remove and replace battery to reset the module. 
 
This equipment shall only be installed and operated with the antenna types shown in this application with gains not 
more than those shown for each of the antennas, respectively, and installed with a minimum of 20 cm of separation 
distance between the antenna and all persons during normal operation.