Taicom Data Systems Co Ltd AWL1000G ユーザーズマニュアル

Annex Mode Config: It allows you to manually configure the Router for Annex A or Annex B
mode by selecting User Configured and choosing the Annex Mode in the next field.

User Selected Annex Mode: It allows you to select from Annex A and Annex B.

Please DO NOT change the default setting of Annex Mode unless you are instructed

to do this by your ISP.

Trellis: Trellis Code is an advanced method of FEC (Forward Error Correction). It allows you to
enable or disable the Trellis Code. By default, it is always enabled.

Handshake Protocol: It allows you to select from the following ADSL handshake protocols:
Autosense - G.dmt first (default), Autosense - T1.413 first, G.dmt/G.lite, T1.413, G.dmt, and G.lite.

Wiring Selection: It allows you to enter the wiring selection for the RJ-11.
Tip/Ring is the default for the Router without the inner/outer pair relay. Available types are Auto,
Tip/Ring (default), and A/A1, where Tip/Ring is the inner-most pair of wires on the RJ11 and A/A1
is the second inner-most pair.

Bit Swapping: It allows you to enable or disable the upstream bit swapping. Bit Swapping is
disabled by default.

6.4 Route Table

The Route Table page displays the routing table and allows you to manually enter a routing entry.
The routing table will display the routing status of Destination, Netmask, Gateway, and Interface.
The interface br0 indicates the USB interface (reserved function); lo0 indicates the loopback
interface; ppp1 indicates the PPP interface. The Gateway is the learned Gateway.