Lg Electronics LST230 ユーザーズマニュアル

 

STEP II.  Place the Terminal

l Place the terminal on the stable flat secure surface area (desk, table, etc.). Avoid direct exposure to the sun

lights and damp area.

l Read the Safety Information located at the first part of this document before you place the terminal.

 

 

STEP III.  Connect Components

l Connect the antenna to the TNC connector located at the topside of the terminal. (See Figure 1 to locate

the TNC connector.) If you placed the terminal on the flat surface, bend the antenna up right.

l Connect your phone cord to the RJ-11C port located at the left side of the terminal.

l Connect the battery cable to the DC battery connector at the back of the main unit.

l Connect the AC power supply cable to the DC input port located at the right side of the terminal.

l If you use Data Service or PC FAX Service, connect your RS-232C cable cord to the DB9 port located at

the right side of the terminal.

l If you use G3 FAX machine, connect your line cord of G3 FAX to the RJ-11 port located at the right side of

the phone port.

 

 

 

STEP IV.  Check LED indicators

l 

When you followed the installation instruction STEP I to STEP III, please check the LEDs for normal
operation.

 When DC power is fed at the first time, LEDs will operate as follows:

1. After few seconds, if receiving signal strength is strong enough, then SIGNAL LED is GREEN, if not, it

is ORANGE or RED. And MODE LED is turned off. Power LED is GREEN if AC/DC power is applied.

 

STEP V.  Install of Wall Mounting

l 

To mount terminal on the wall, please follow the procedure to install it correctly.
1. Determine suitable location to mount terminal with mounting template;
2. Mark the two openings and select round or panhead type screw;
3. Drill out the holes with drill bit smaller in diameter than the screws
4. Secure two screws into the wall, leaving about 1/8inch gap between the screw heads and the wall;
5. Insert the DC power pack into an electrical outlet and attach the telephone line into the Phone Jack (RJ-

11) of the unit.

6. Place the terminal over the two screws so that the screw head protrudes out of the 

opening;

7. Slide the terminal downward until the screw head is locked at the top of the opening and the terminal is

secure;

8. Tighten the screws the terminal is resting upon;