TransCore 05531 ユーザーズマニュアル
General Software Information
5-5
Operating Parameters
The Encompass 4/4800 Multiprotocol Readers maintain their operating parameters in
non-volatile memory (NVRAM) so that the parameters are preserved after a power-
down sequence.
non-volatile memory (NVRAM) so that the parameters are preserved after a power-
down sequence.
Power Fail
The system maintains a power fail flag. The host transmits command #520 Display
Power Fail Bit to determine if a power down has occurred. This flag is cleared by both
command #63 Reset Reader and command #65 Reset Power Fail Bit.
Power Fail Bit to determine if a power down has occurred. This flag is cleared by both
command #63 Reset Reader and command #65 Reset Power Fail Bit.
Program Download
Program download stores the Encompass 4/4800 Multiprotocol applications software
into the Encompass 4/4800 Multiprotocol Reader’s flash memory. Program download
is used to install program upgrades, add features, and to recover from corrupted pro-
gram data. The download mode supports a limited set of commands: #90 Load Pro-
gram Block, #91 Verify Flash Checksum, #96 Erase Flash Memory, #97 Perform
Destructive Memory Test, and #99 Exit Download Mode.
into the Encompass 4/4800 Multiprotocol Reader’s flash memory. Program download
is used to install program upgrades, add features, and to recover from corrupted pro-
gram data. The download mode supports a limited set of commands: #90 Load Pro-
gram Block, #91 Verify Flash Checksum, #96 Erase Flash Memory, #97 Perform
Destructive Memory Test, and #99 Exit Download Mode.
Download Considerations
You should consider the following factors when performing program download:
•
The Encompass 4/4800 Multiprotocol Reader does not process tags while in
download mode.
download mode.
•
The Encompass 4/4800 Multiprotocol Reader accepts only download commands
while in download mode. It responds to all other commands with an e
while in download mode. It responds to all other commands with an e
rror
mes-
sage.
•
The Encompass 4/4800 Multiprotocol Reader does not accept any program data
unless a successful erase of flash memory has been performed before transmitting
the data. Erasing the flash memory typically takes seven seconds.
unless a successful erase of flash memory has been performed before transmitting
the data. Erasing the flash memory typically takes seven seconds.
•
Exiting from download mode re-executes startup. If the new software has been
loaded without errors, the Encompass 4/4800 Multiprotocol Reader comes up in
data mode. If a flash checksum error is detected, the Encompass 4/4800 Multipro-
tocol Reader reenters download mode and transmits a sign-on message with a
boot version of 0.00x and without a serial number.
loaded without errors, the Encompass 4/4800 Multiprotocol Reader comes up in
data mode. If a flash checksum error is detected, the Encompass 4/4800 Multipro-
tocol Reader reenters download mode and transmits a sign-on message with a
boot version of 0.00x and without a serial number.
Note: The Encompass 4/4800 Multiprotocol Reader uses default communications
parameters when operating in download mode
parameters when operating in download mode
–
9600 baud, 8 data bits, 1 stop bit, no
parity, basic protocol
–
and does not echo commands.