Bureau D' Electronique Appliquee Inc 210193 ユーザーズマニュアル
Jean-Pierre LERUTH
Print : 09/03/2012
Page 3 / 3
4. Regulatory Compliance
•
This device has been tested and approved to be compliant with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada.
Operation is subject to the following conditions:
(1)
This device may not cause harmful interferences, and
(2)
This device must accept any interference received, including interference that may
cause undesired operation.
4.1
FCC & IC Instructions
•
Changes or modifications made to the equipment not expressly approved by BEA Inc. may
void the FCC authorization to operate this equipment.
•
The use of the BEA-T1B transceiver is authorized into mobile or fixed devices taking into
account the conditions listed below :
(1)
OEM Integrator may be sure that the end user manual may not contain any
information about the way to install or remove the module from the final product.
(2)
The following information is required to be incorporated in the user manual of the final
system:
- This device has been tested and approved to comply with Part 15B unintentional
radiator requirements
- The antenna of the module may not be removed, replaced nor modified. The
antenna must not be co-located or operating in conjunction with any other
antenna or transmitter. No additional antenna must be used.
antenna or transmitter. No additional antenna must be used.
- This device may not cause harmful interferences, and this device must accept any
interference received, including interference that may cause undesired operation.
(3)
The module must be installed and used in strict accordance with the manufacturer’s
instructions as described in the user documentation that comes with the product.
(4)
Power supply of the module must be conform to the electrical specifications as
described in § 2 of the current user manual.
(5)
The antenna of the module may not be removed, replaced nor modified. The antenna
must not be co-located or operating in conjunction with any other antenna or
transmitter. No additional antenna must be used.
transmitter. No additional antenna must be used.
(6)
OEM integrator is responsible for ensuring that after the module is installed and
operational into the host, it continues to be compliant with the Part 15B unintentional
radiator requirements.
radiator requirements.
(7)
A label with the words ‘Contains FCC ID:G9B-210193’ and ‘Contains IC:4680A-
210193’ shall be applied and visible from the outside of the end product.