Psion Inc 7505BTHC25 ユーザーズマニュアル
A-6
iKôn Rugged PDA (Windows Mobile 6) User Manual
Appendix A: Summit Client Utility (SCU)
ThirdPartyConfig
ThirdPartyConfig
•
When prompted, you can enter valid credentials, enter invalid credentials, or cancel the
operation.
•
If you enter valid credentials and tap OK, the radio will associate and authenticate.
•
If you enter invalid credentials and tap on OK, the radio will associate but will not
authenticate; you will be prompted again to enter credentials.
•
If you tap on Cancel or clear the credentials fields and tap on OK, the radio will not
attempt to associate with that config until you perform one of the following actions
(while the config is the active config):
- Cause the iKôn PDA to go through a power cycle or suspend/resume.
- Disable and enable the radio, or tap the Reconnect button on the Diags windows.
- Modify the config, and tap on Commit.
- Cause the iKôn PDA to go through a power cycle or suspend/resume.
- Disable and enable the radio, or tap the Reconnect button on the Diags windows.
- Modify the config, and tap on Commit.
Alternatively, you can choose another config as the active config and then switch back to the
config for which EAP authentication was cancelled.
config for which EAP authentication was cancelled.
A.3.3
ThirdPartyConfig
If you choose to configure ThirdPartyConfig, the SCU will work with the operating sys-
tem’s Windows Zero Config (WZC) to configure radio and security settings for the CF radio
installed in the unit.
Choosing this config means that WZC must be used to define the following radio and secu-
rity options: SSID, Auth Type, EAP Type and Encryption.The SCU settings for
ThirdPartyConfig include: Client Name, Power Save, Tx Power, Bit Rate and Radio Mode.
These SCU settings along with SCU global settings and the WZC settings will be applied to
the radio module.
tem’s Windows Zero Config (WZC) to configure radio and security settings for the CF radio
installed in the unit.
Choosing this config means that WZC must be used to define the following radio and secu-
rity options: SSID, Auth Type, EAP Type and Encryption.The SCU settings for
ThirdPartyConfig include: Client Name, Power Save, Tx Power, Bit Rate and Radio Mode.
These SCU settings along with SCU global settings and the WZC settings will be applied to
the radio module.