Code Systems Inc PAN04 ユーザーズマニュアル

 

The TX540 transmitter is a replacement RF transmitter.  The transmitter 

comes with 4 push-button switches. 

 

1)  Press Upper and LEFT push-button switch on control first receiver (Your 

alarm system) 

2)  Press Upper and RIGHT push-button switch on control first receiver (Your 

alarm system) 

3)  Press Lower and LEFT push-button switch to control second receiver (It 

can be an alarm system or electric device). 

4)  Press Lower and RIGHT push-button switch to control second receiver (It 

can be an alarm system or electric device). 

 

TRANSMITTER BATTERY REPLACEMENT 

 

If the range of your transmitter deteriorate, it is possible that you need to 

replace the battery. 

1)  Release the screw from the back of transmitter and remove upper 

transmitter case. 

2)  Remove old battery from transmitter. 

3)  Install a new battery (12 volt) noting the (+) and (-) marks in the battery area 

of the transmitter. 

4)  Replace upper transmitter case with area, do not damage the inside 

components. 

5)  Tighten the screw on the back of transmitter. 

 

This device complies with part 15 of the FCC rules.  Operation is subject to 

the following two conditions. 

1)  This device may not cause harmful interference, and 

2)  This device must accept any interference received, including interference 

that may cause undesired operation. 

 

CAUTION: Changes or modifications not expressly approved by the 

manufacturer responsible for compliance could void the user’s authority to 

operate the equipment.