Visonic Inc. PWRMCOMPLETE ユーザーズマニュアル

READING THE EVENT LOG

D-300886

8. Reading The Event Log

Event Log Description

All events are memorized in an event log. You can
access this log, review the events one by one and
draw functional conclusions.

If the event log fills up completely it continues to
accept new events at the expense of old events - the
oldest event is deleted upon registration of each new
event.

The date and time of occurrence are memorized for
each event. When reading the event log, events are
shown in chronological order - from the newest to the
oldest.

Because of the limited display space, the event
description is shown first, then the date and time.
The two displays are shown alternately several

times, until you click

to move on to an

older event, or until the “no action” 4-minute timeout
restores the system to the normal operating mode.

Access to the event log is provided by clicking the
asterisk (

$) key and then keying your master user

code.

Should you wish to get an overall view of using
the log, refer to Figure 9. The flow chart may
even serve as your only guide to using the event
log, instead of going through the written step-by-
step procedure.

Attention: The system

will not allow you to

erase the event log.

Only the installer is

authorized to view and

perform this function

Oldest Event

Event Before Last

Latest Event

LIST OF EVENTS

ENTER CODE _ _ _ _

(Enter 4-digit

master user code)

<OK TO EXIT

CLEAR EVENT LOG

(Return to normal

operation)

&
&

Figure 9. Using the Event Log

Reading Procedure

To read the event log, proceed as follows:

A. While the system is in the normal operating

mode, click the asterisk (

$) key. The display will

change to:

ENTER CODE _ _ _ _

B. Enter the current master user code. If the code is

correct, the “Happy Tune“ will sound and the
display will read:

LIST OF EVENTS

Important! Entering an incorrect code 5 times in
a row will initiate a 30-second penalty lockout of
the keypad.

C. Click

. The latest event will be

shown. Suppose that the latest event was an
alarm in zone 13. The display will now read:

Z13 ALARM

and then:

09 / 02/ 99 3:37 P

The two displays will be shown alternately until

you click

again to move to the next

event, or until the event log times out (4 minutes).

D. Click

as many times as necessary

to read all the data you need.

To quit the event log:

- Click

from any-

where within the log. The display
will read:

<OK> TO EXIT

- Click

. The

system will return to the normal
operating mode.