Visonic Inc. PWRMCOMPLETE ユーザーズマニュアル
SECURING THE PROTECTED SITE
8
D-300886
2. Securing The Protected Site
2. Securing The Protected Site
2. Securing The Protected Site
2. Securing The Protected Site
Security
Security
Security
Security----Related Pushbuttons
Related Pushbuttons
Related Pushbuttons
Related Pushbuttons
Key Function
Arming when nobody is at home
Arming when people remain at home
Canceling the entry delay upon arming
(‘AWAY-INSTANT’ or ‘HOME-INSTANT’)
(‘AWAY-INSTANT’ or ‘HOME-INSTANT’)
Disarming the system and stopping
alarms
alarms
Testing the system (see Chapter 6 -
Conducting Walk Test).
Conducting Walk Test).
Preparing to Arm
Preparing to Arm
Preparing to Arm
Preparing to Arm
Before arming, make sure that READY is displayed:
READY HH:MM
If Ready is displayed, all zones are secured, and you
may arm the system any way you choose.
may arm the system any way you choose.
If at least one zone is open (disturbed), the display
will read:
will read:
NOT READY HH:MM
If NOT READY is displayed because of unsecured
zone, click
to review the numbers and
names of all open zones one by one.
Let us assume that zone 2 (the back door) and zone
13 (the kitchen) are open. To investigate, proceed as
follows:
13 (the kitchen) are open. To investigate, proceed as
follows:
PRESS RESULTANT
DISPLAY
NOT READY HH:MM
BACK DOOR
(alternating)
Z2 OPEN
KITCHEN
(alternating)
Z13 OPEN
!
!
(after 10 seconds)
!
None (see
note below)
note below)
NOT READY HH:MM
Note: To quit immediately at any stage, press
.
It is highly recommended to fix the open zone(s),
thus restoring the system to the state of “ready to
arm”. If you do not know how to do this, consult your
installer.
thus restoring the system to the state of “ready to
arm”. If you do not know how to do this, consult your
installer.
IMPORTANT! All arming procedures below are
based on the assumption that quick arming has been
enabled by the installer. If quick arming is disabled,
the PowerMaxComplete will prompt you to enter
your security code before arming.
based on the assumption that quick arming has been
enabled by the installer. If quick arming is disabled,
the PowerMaxComplete will prompt you to enter
your security code before arming.
Arming ‘AWAY’
Arming ‘AWAY’
Arming ‘AWAY’
Arming ‘AWAY’
If the system is READY, proceed as shown:
PRESS RESULTANT
DISPLAY
ARMING AWAY
↓
PLEASE EXIT NOW
Vacate the premises
↓
(Exit delay)
↓
AWAY
ARM indicator lights steadily during the armed
state.
Arming ‘HOME’
Arming ‘HOME’
Arming ‘HOME’
Arming ‘HOME’
If all perimeter zones are READY, and quick arming
is allowed, proceed as shown:
is allowed, proceed as shown:
PRESS RESULTANT
DISPLAY
ARMING HOME
Move to interior
zone
zone
↓
(Exit delay)
↓
HOME HH:MM
ARM indicator flashes during the armed state.
Switching from ‘HOME’ to ‘AWAY’
Switching from ‘HOME’ to ‘AWAY’
Switching from ‘HOME’ to ‘AWAY’
Switching from ‘HOME’ to ‘AWAY’
Do not disarm the system - just press
. The
response will be the same as in ARMING AWAY
above. Vacate the premises before the exit delay
expires.
above. Vacate the premises before the exit delay
expires.