Climax Technology Co Ltd CO ユーザーズマニュアル
1
CO-8ZW Carbon Monoxide Detector
Introduction
CO-8 is a Carbon Monoxide Detector. It is capable of sending wireless signals to the Z-Wave
Gateway/Control Panel upon detection of Carbon Monoxide concentration.
Gateway/Control Panel upon detection of Carbon Monoxide concentration.
The Carbon Monoxide Detector is a Z-Wave enabled device and is fully compatible with any Z-Wave
enabled network.
enabled network.
Z-Wave is a wireless communication protocol that uses a low-power RF radio. By taking advantage of
the Z-Wave mesh network, commands can be transmitted to their destination via intermediary “listening”
Z-Wave products.
the Z-Wave mesh network, commands can be transmitted to their destination via intermediary “listening”
Z-Wave products.
Parts Identification
1. Dual Color LED indicator (Amber/Red)
The LED indicator lights up in the following conditions:
- Red LED flashes twice
The Carbon Monoxide Detector has successfully included
(learnt) into Z-Wave Gateway/Control Panel.
(learnt) into Z-Wave Gateway/Control Panel.
- Red continuous flash:
The Carbon Monoxide Detector is activated.
- Amber LED flashes every second:
The Carbon Monoxide Detector is in Alarm Silence mode.
2. Function Button
- Press the button once to send a supervision signal.
- Press the button once during alarm to silence the alarm.
- Press and hold the button 3 times within 1.5 seconds to send a
- Press the button once during alarm to silence the alarm.
- Press and hold the button 3 times within 1.5 seconds to send a
learn code.
- Press and hold the button for 10 seconds to factory reset.
3. Battery Compartment
The Carbon Monoxide Detector is powered by three
AA Alkaline 1.5V batteries.
AA Alkaline 1.5V batteries.
4. Mounting Hole
5. Mounting Bracket
Features
z
z
C
C
a
a
r
r
b
b
o
o
n
n
M
M
o
o
n
n
o
o
x
x
i
i
d
d
e
e
D
D
e
e
t
t
e
e
c
c
t
t
i
i
o
o
n
n
z
The Carbon Monoxide Detector will be activated according to the following table when CO
concentration is detected.
concentration is detected.
CO concentration
level
Time taken before
alarming
30 ppm
None
50 ppm
60-90 minutes
100 ppm
10-40 minutes
300 ppm
Under 3 minutes
z
Once the CO concentration level exceeds the threshold and persists for the time length as
listed in the above table, the Carbon Monoxide Detector will transmit the signal to the Z-Wave
Gateway/Control Panel and raise alarm with its built-in siren.
listed in the above table, the Carbon Monoxide Detector will transmit the signal to the Z-Wave
Gateway/Control Panel and raise alarm with its built-in siren.
z
After the alarm has been activated, the Carbon Monoxide Detector will continue to send the
alarm signal every 2 minutes as long as CO concentration remains above 30 ppm.
alarm signal every 2 minutes as long as CO concentration remains above 30 ppm.
z
If the CO concentration drops below 30 ppm, the Carbon Monoxide Detector will stop alarming
and transmit a restore signal
and transmit a restore signal