Climax Technology Co Ltd SDZB ユーザーズマニュアル

 

1

SD-8ZBS-EL is a ZigBee Smoke Detector. It is capable of sending wireless signals to the coordinator in 
the ZigBee network upon detection of smoke particles. The Smoke Detector is designed to be mounted 
on ceiling or top of stairwells when smoke would concentrate to raise alarm timely and protect your 
home from fire hazards. 
The Smoke Detector utilizes ZigBee technology for wireless signal transmission. ZigBee is a wireless 
communication protocol that is reliable and has low power consumption and high transmission efficiency. 
Based on IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network 
and coordinated for data exchange and signal transmission 
The Smoke Detector serves as an end device in the ZigBee network. It can be included in the ZigBee 
network to transmit signal upon activation, but cannot permit any other ZigBee device to join the 
network through the Smoke Detector.   
 

- Press the button once to send a supervision signal. 
- Press the button once during alarm to silence the alarm. 
- Press and hold the button for 10 seconds then release to reset 

the Smoke Detector. 

- Press and hold the button for 20 seconds then release to 

recalibrate the Smoke Detector. 

The LED indicator lights up in the following conditions: 

- Continuous quick flashes   

The Smoke Detector is alarming. 

- Two quick flashes   

The Smoke Detector has successfully joined a ZigBee network 
after factory reset. 

- Flashes once every 20 minutes: 

The Smoke Detector has lost connection to its current ZigBee 
network. 

- Flashes every 2 seconds: 

Battery Exhausted 

- Flashes every second: 

The Smoke Detector is performing self-calibration 
or 
The Smoke Detector is in Alarm Silence mode. 

- Press the button once to send a supervision signal. 
- Press and hold the button for 10 seconds then release to reset 

the Smoke Detector. 

The Smoke Detector is powered by three AA Alkaline 
1.5V batteries.