Climax Technology Co Ltd SVGSF1 ユーザーズマニュアル

SVGS-1 is a Shock, Vibration/Glass Break Sensor. It is capable of sending wireless signals to the coordinator in the RF network 
upon detection of window glass break or shock/vibration. 
 

 

Using sharp tools such as paper clip to press the button and transmit Lear/Test code. 

The LED flashes when: 

-  The Learn/Test button is pressed. 

-  The sensor has detected shock/vibration.   

 





 

  Battery and Low Battery Detection 

 

The Sensor use one CR2032 3V Lithium battery as its power source. Please note: ALWAYS replace battery with the 

correct size and voltage. 

 

The battery is pre-inserted in the sensor. Pull out the battery insulator to activate battery. 

 

The Sensor can detect if the battery is low. When the Battery is low, a low battery signal will be sent to the Control 

Panel along with regular transmission. 

 

When changing battery, use a sharp tool to open the battery slot to remove and insert battery. 

 

When inserting batteries, the positive(+) side of the battery must face upward. NEVER insert the battery with 

negative(-) side facing upward. 

 

When the battery is inserted, the LED indicator will light up briefly. 

 

 

  Supervision 

The

 

Sensor will transmit a supervision signal to report its condition regularly according to the user’s setting. The factory 

default interval is 30-40 minutes. The user can also press the Function Button once to transmit a supervision signal 
manually. 

  Sensitivity 

The Sensor can send alarm signal to the Control Panel according to different sensitivity levels setting. The sensitivity 
levels include high, medium, and low (default). The higher the sensitivity; the easier the sensor is triggered by 
shock/vibration. 

To adjust the sensitivity setting: 

1  Remove the battery. 

2  Reinsert the battery, the LED indicator will light up briefly for about 1 second. 

3  Press and hold the Learn/Test button when the LED indicator is lit up. 

4  The LED will begin to flash 3 times: 

I.  Release the button when the LED flash for the first time to set sensitivity to Low. 

II.  Release the button when the LED flash for the second time to set sensitivity to Medium. 

III. Release the button when the LED flash for the third time to set sensitivity to High. 

 

 

 

The detection range of different sensitivity varies depending on the mounting surface materials.