Fimi Srl 802180 ユーザーズマニュアル
VERIFICATION ONLY
46
NOT RELEASED
7 Troubleshooting
7.1 My NGP1 Computing Platform is not turning ON.
Make sure that the battery is properly inserted and latched or the AC adapter is fully
connected or that the unit is well docked.
Plugging the AC adapter into the DC in jack located under the protective cover on the
connected or that the unit is well docked.
Plugging the AC adapter into the DC in jack located under the protective cover on the
bottom of the unit, makes sure that the Adapter is also plugged into the wall socket.
If running with battery only, be sure that the inserted battery pack has some capacity left.
If running with battery only, be sure that the inserted battery pack has some capacity left.
7.2 My NGP1 Computing Platform Power on LED is ON, but
nothing happens.
Make sure that the unit is not is stand-by by tapping on the screen.
As a last resort remove the power cord and the battery, wait ten seconds then insert
As a last resort remove the power cord and the battery, wait ten seconds then insert
again the battery and power cord, restarting a power on procedure.
7.3 My NGP1 Computing Platform does not run smoothly
Simultaneous opening of too many applications will cause deterioration in application
performance.
To free up memory, close applications that are not in use, especially if they are CPU or
performance.
To free up memory, close applications that are not in use, especially if they are CPU or
memory intensive (e.g. video playback)
If networked, Check wireless signal quality:
When the WLAN icon indicator in the icon tray is green, a wireless signal is available. If
When the WLAN icon indicator in the icon tray is green, a wireless signal is available. If
you position your pointing device over it, you can get info about the current connection
and the related signal strength.
and the related signal strength.
.Otherwise, double taps the Network icon on the bar at the bottom of the screen. Choose
the Wireless Information tab to show the current connection Access Point, or try
repositioning the antenna of the access point.
repositioning the antenna of the access point.
7.4 How do I turn off my NGP1 Computing Platform
To end operation, press the Power / Stand-by on the NGP1 Computing Platform right side.
Or tap the “START Menu” and then choose “Shut Down” to turn off the pad (if Windows is
installed).
Or tap the “START Menu” and then choose “Shut Down” to turn off the pad (if Windows is
installed).
Note: Pressing the Power button of the device for more then five seconds
will make a hard turn OFF preventing the Operating System to perform
will make a hard turn OFF preventing the Operating System to perform
the correct shutdown procedure. This is an extreme remedy in case the
device is not responding.
7.5 When I use the touch screen.
7.5.1 the cursor is not following the pen movement.
If you have just booted the system, allows more time for the touch functions to come up.
7.5.2 . the system does not respond to taps.
Be sure that you are tapping on a target (e.g. an icon) . If there is a misalignment
between pen tip and Windows indicator, please perform a new calibration, once that you
have realized that this is not due to the viewing angle with which you are operating the
system
have realized that this is not due to the viewing angle with which you are operating the
system
Note: You might need to practice a couple of time in to operate your
screen with taps. Please customize the pen action: