DTC Communications Inc. PD2TX100S ユーザーズマニュアル
DTC COMMUNICATIONS, INC.
4
TELEMETR
Y
CHANNEL
Palladium II
VIDEO TX
Antenna
Audio
Camera
Battery Pack
Power Option
1 Connect the transmitter antenna to the SMA connector on the bottom of
the Palladium unit.
2 If you plan to use audio, connect one or two microphones to the Audio 1
and/or Audio 2 LEMO connectors. If using monaural, use Audio 1.
3 Connect power and video input via the Multi I/O cable to the 6-pin
Hirose connector:
a Attach your camera video input (75 ohm composite video source in
PAL or NTSC) to the Multi I/O cable BNC connector.
PAL or NTSC) to the Multi I/O cable BNC connector.
b Apply the necessary power to your camera (use supplied cable or
external source) and turn ON.
external source) and turn ON.
c Attach a 12 VDC power source (such as the supplied battery pack or
the AC power adapter) to the Multi I/O cable via the Molex connector.
The input voltage range is from 10 to 16 VDC.
the AC power adapter) to the Multi I/O cable via the Molex connector.
The input voltage range is from 10 to 16 VDC.
WARNING: Do not apply power to the transmitter unless an antenna
or non-radiating load is connected to the Antenna SMA connector.
or non-radiating load is connected to the Antenna SMA connector.
Complete these steps:
1
2
3
Palladium Transmitter, Top View
QUICK START
Typical Wiring Configuration
A2
L
L
A1
R/M
R/M