HeathCo LLC 60WRC31TX ユーザーズマニュアル

DRAFT COPY

FEATURES

• Products are UL/cUL and/or FCC/IC tested and approved.
• Operational range of up to 100 feet.

Heath

/Zenith wireless lighting controls are designed to work

together. Simply determine which transmitter(s) you would
like to have control which receiver(s) and set the code setting
to match.

• Transmitters

– Remote Control
– Indoor Wireless Motion Sensor

Remote Controlled Products

This manual includes operating instructions for a variety of remote controlled products. All products work on the same principle and use the
same code setting information. Please read all instructional information and note any specific information pertaining to your particular product.

WARNINGS:
• FOR USE ONLY with 120 volt incandescent or halogen bulbs.
• DO NOT USE with fluorescent bulbs, appliances, power supplies, low voltage lighting, or any other electrical devices.

CODE SETTINGS

Note:

Most single system installations will not require any

change to the code setting. Transmitter(s) and receiver(s)
must have the same code and group setting to work to-
gether. Switches 1 through 3 set the code. Switch 4 sets the
Group (A or B). See page 2 for switch locations.

DIM

OFF

DIM

Receiver(s)

Code

Receiver(s)

Code

Group A

Group B

Remote Motion

Sensor Code

Group A

Example 1 - Code Switch Settings, System 1

(Factory Setting)

Controls Group “A”

Receiver(s) and

Transmitter(s)

Controls Group “B”

Receiver(s) and

Transmitter(s)

Note:

When operating more than one system independently of

each other, set each system to a different code. There are 8 codes
available by changing the settings of switches 1 through 3.

Example 2 - Code Switch Settings, System 2

Receiver(s)

Code

Receiver(s)

Code

Group A

Group B

Remote Control

Code

When using a single group transmitter (

i.e.

Door Transmitter, Add-

A-Switch, Remote Motion Sensor) the code and group settings
must match receiver(s) for the system to function properly.

This manual applies to the following products:

Group Switch
Not Used on Remote

Note:

The channel can also be changed to reduce interference

problems from other wireless products (

i.e.

wireless phones,

garage door openers, etc.). See

Troubleshooting Guide

for more

information.

Receiver(s)

Code

Group A

Remote Control

Code

Group Switch
Not Used On Remote

Example 3 - Code Switch Settings with Single Transmitter

Note:

This setting will work independently of examples 1 and 2

because the code setting is different.

(

– Indicates Position of Switch)

598-1116-07

ENGLISH