HeathCo LLC 64WDB42TX ユーザーズマニュアル

This package includes (Style of push button and chime may vary from illustration):
•

Wireless chime

•

Wireless push button w/battery (Specific models include 2)

•

Hardware pack

This device is for use with 120VAC, 60 Hz. DO NOT EXCEED RECOM-
MENDED VOLTAGE.

Run wiring to electrical box using approved
wiring. Connect the two wires from the house
wiring using supplied UL approved wire nuts.
Connect the black wire from chime to the black
wire from house. Connect the white wire from
chime to the white wire from house.

© 2002 DESA International

598-1123-00

Figure 2

Locate an approved, vertically mounted,
single gang, rectangular electrical box in
the wall. It is recommended that the chime be
located approximately six (6) feet above the
floor for best sound travel and appearance.

Figure 1

Install two lithium type CR1220 3 volt
push button batteries (included). Remove
back of case by pushing in tab on bottom
with a small screwdriver. Make sure batter-
ies are oriented properly (see page 3).

  Mount chime and push button. Attach

chime unit to rectangular electrical box us-
ing two screws provided. Insert screws into
screw holes as shown in Figure 2. Note:
Chime can only be mounted in vertical posi-
tion. Use arrow on rear of chime unit as a
guide. Turn on household power.