Horizon Hobby LLC BLH8850 ユーザーズマニュアル

The LEDs indicate the front and back of the quadcopter. The white LEDs 

indicate the front. The red LEDs and tail light indicate the back.
Takeoff

Arm the motors by pressing the arming switch. Increase the throttle 

until the model is approximately 2 ft. (600mm) off the ground in a low-

level hover and concentrate on balancing the throttle stick’s position so 

that the quadcopter holds a steady hover altitude. In some cases, you 

may need to make a few short “hops” to an altitude of just a few inches 

until you become familiar with the control inputs and trim settings 

required to maintain a steady hover and altitude. 
Hovering
The Inductrix

®

 quadcopter requires minor throttle adjustments to 

maintain its altitude in hover. Remember to keep these throttle 

adjustments as minimal as possible. Large adjustments could result in 

a loss of control or a possible crash.
While attempting to establish a low-level hover, check to see if any 

trim adjustments are required to keep the quadcopter from drifting 

in various directions. If you find that it constantly drifts without any 

directional control input, land the model before making any adjustments 

to the trim settings.

• If the nose of the quadcopter rotates to the left or right, adjust the 

rudder trim in the opposite direction.