Horizon Hobby LLC HBZ4771 ユーザーズマニュアル
Transmitter Setup
1. Remove the transmitter back cover.
2. Install the included “AA” batteries. Use four fresh 1.5V “AA”
2. Install the included “AA” batteries. Use four fresh 1.5V “AA”
batteries only.
3. Be sure to observe proper polarity when installing the
batteries, and then replace the cover.
4. To test, switch on the transmitter. The LED should glow
brightly
5. Replace the batteries when you hear the low battery
alarm(beeping sound)
Note: You many notice a small switch immediately below
the LED and the power switch.
This small switch determines the controls for the
transmitter with default position to the left.
It is not recommended to change it.
Note: You many notice a small switch immediately below
the LED and the power switch.
This small switch determines the controls for the
transmitter with default position to the left.
It is not recommended to change it.
Motor Test and Battery Discharging
1.
Turn on transmitter.
2.
Install the flight battery into fuselage and
plug it into the connector
3.
Move the transmitter’s left stick all the way
down and hlod for one second. This will arm the
motor.
motor.
4.
Move the transmitter’s left stick up. Since
most batteries come partially changed, the prop
should spin at high spped. (If the motor does not run.
Proceed to charging the battery.)
should spin at high spped. (If the motor does not run.
Proceed to charging the battery.)
5.
In order to fully discharge the battery, run
the motor at high speed until it shuts off. If there is
not enough charge in the battery to power the
not enough charge in the battery to power the