Tyco Safety Products/Sensormatic AMB9010 ユーザーズマニュアル
Preliminary
ZBAMB9010-IPS EAS LABEL DEACTIVATION CONTROLLER
8200-0747-24 REV. 3A
INSTALLATION GUIDE
4 OF 7
PRECAUTIONS
Please read the following precautions for:
Safety
Cleaning
Device interaction
Installation.
SAFETY
WARNING!
Hazardous areas.
DO NOT install this product in areas
where highly combustible or explosive
products are stored or used.
where highly combustible or explosive
products are stored or used.
Power considerations.
Plug this product into an unswitched
AC outlet with less than 0.5Vac
between neutral and ground. This
product is designed to be operated on
a power system that includes a
protective earth terminal.
between neutral and ground. This
product is designed to be operated on
a power system that includes a
protective earth terminal.
DO NOT connect to UPS power.
DO NOT plug or unplug any cable
with power on.
When the cordset is not provided with
this product, a cordset certified to the
national requirements of the country
of installation must be used.
national requirements of the country
of installation must be used.
Altitude limitation.
This product is evaluated for use at
altitudes up to 3200m (10,500ft).
altitudes up to 3200m (10,500ft).
WARNING
—
RISK OF ELECTRIC SHOCK!
No user-serviceable parts.
DO NOT attempt to open this product.
Power cord / cable routing.
Route the power cord and deactivation
cables away from mechanisms whose
operation may pinch or otherwise
damage it. Failure to do so may damage
equipment or injure people nearby.
cables away from mechanisms whose
operation may pinch or otherwise
damage it. Failure to do so may damage
equipment or injure people nearby.
Cleaning
Wipe the housing with a soft cloth
moistened (not soaked) with mild
detergent. Then wipe off excess.
moistened (not soaked) with mild
detergent. Then wipe off excess.
Keep spills from entering the housing.
DO NOT USE:
Spray cleaners.
Ammonia- or chlorine-based
cleaning solutions; they may
damage the housing or corrode
internal parts.
damage the housing or corrode
internal parts.
Abrasives, solvents, or flammable
liquids.
Installation
Ventilation.
Install the controller in a location that
has adequate free space around it and is not likely
to be cluttered with debris.
to be cluttered with debris.
Sidewall mounting.
When the controller is
mounted to a sidewall of a counter, its cable
connectors MUST NOT face down.
connectors MUST NOT face down.
Cable reach.
Make sure the pad or coil cable can
reach the controller. Make sure the power cord and
power supply cable once plugged into the
controller can reach the AC outlet.
power supply cable once plugged into the
controller can reach the AC outlet.