Tyco Safety Products/Sensormatic DEACSLNK ユーザーズマニュアル
Preliminary
AMC-4010 SYNCHRONIZATION MODULE INSTALLATION AND SERVICE GUIDE (8200-0183-01, REV. 03)
1 of 5
ZPSYNC4010 Wireless
ZPSYNC4010 Wireless
Sychronization
Sychronization
Modules
Modules
Setup Guide
Setup Guide
Wireless synchronization modules can significantly
reduce electrical interference between Sensormatic
EAS systems timed to the AC line. A module
system includes a module designated as a
transmitter and one or more modules designated
as receivers.
reduce electrical interference between Sensormatic
EAS systems timed to the AC line. A module
system includes a module designated as a
transmitter and one or more modules designated
as receivers.
IMPORTANT! Ensure EAS devices can support
wireless synchronization.
wireless synchronization.
IMPORTANT! The maximum distance between the
transmit module and any receive module is
approximately 60.1m (200 feet), but keep in mind
that the range depends upon the environment in
which the module is used. Many factors can limit
the range, thus it would be impossible to list them.
transmit module and any receive module is
approximately 60.1m (200 feet), but keep in mind
that the range depends upon the environment in
which the module is used. Many factors can limit
the range, thus it would be impossible to list them.
© Sensormatic 2002
For best performance, please follow these
instructions carefully.
instructions carefully.
Parts Supplied
Parts Supplied
Sync Link Module
1
0304-0029-01
Cable Ties
3
?
Cable
1
?
Mechanical Specifications
Mechanical Specifications
Dimensions: 82mm (L) x 60mm (W) x 30mm (D)
Weight: 2.5 oz
Transmit Frequencies
Transmit Frequencies
North America Frequency Hop: 903.2–914.8 MHz
Europe Single Low frequency: 869.8 MHz
Europe Single High frequency: 869.9 MHz
Setting Up the Transmitter
Setting Up the Transmitter
1. Find the EAS device that is central and within
60.1m (200 feet) of the others. Designate this
device for use with the transmit module.
device for use with the transmit module.
IMPORTANT! DO NOT designate a mobile
checkout stand or use with the transmit
module. Only receive modules can be used
with mobile checkout stands.
checkout stand or use with the transmit
module. Only receive modules can be used
with mobile checkout stands.
2. Configure one module as the transmitter by
opening it and setting switch 7 to OFF (see
Table on page 3). To access the switch,
remove the holding screw and carefully
separate the top and bottom covers (the side
label serves as a hinge between the two
covers. DO NOT remove this label).
Table on page 3). To access the switch,
remove the holding screw and carefully
separate the top and bottom covers (the side
label serves as a hinge between the two
covers. DO NOT remove this label).