Tyco Safety Products/Sensormatic UMPHSR-T ユーザーズマニュアル

User’s Guide

8000-2668-01, Rev. A (2 pages)

ULTRA•MAX EAS PRODUCTS

Ultra•Max

Hand-Held Verifier

About the Unit

The Ultra•Max hand-held verifier is a battery-
operated, rechargeable, device used to:

•

detect active Ultra•Max labels or tags at store

exits so they can be returned to the checkout
counter for proper deactivation or removal.

•

audit incoming merchandise for source tagging

compliance.

The verifier works by generating a short-range
field and then listening for signal from an active
Ultra•Max label or tag. If a signal is detected, the
verifier alarms. The verifier consists of a:

•

Wand

•

Wall-mounted

charger

•

Power

supply

Installing the Charger

IMPORTANT! To ensure installation complies with
all applicable codes and regulations, install the
charger exactly as follows:

1. Using two screws provided, mount charger

vertically to any flat surface with its open end
facing up (see diagram).

2. Plug cord of power supply into side of charger.

3. Plug power supply into an AC wall outlet.

Green light on charger should light.

Charging the Wand

1. With the lights on the wand facing you, slide

handle of wand into tube of charger and push
down.

a. Top light on charger turns red to indicate

charging, which can take up to 10 hours
max. When top light turns green, wand is
fully charged. Wand should be fully charged
before using it for the first time.

b. This product uses a nickel cadmium battery.

To maximize battery life, fully discharge
battery before recharging.

c. Power supply may get slightly warm during

charging (this is normal).

2. Remove wand from charger. Charge should

last for about 5 hours.

WARNING: Place wand in charger only for
recharging, not for routine storage. If you want to
use charger for storage, then unplug power supply
when not recharging.

Wand

Charger

Power Supply