Scientific Toys Ltd 4817-24RR ユーザーズマニュアル

ページ / 1
OUTPUT: 12V DC, 500mA
TOYS“R”US, INC., WAYNE, NJ 07470
TOYS“R”US (CANADA) LTD. (LTÉE),
2777 LANGSTAFF ROAD, CONCORD, ON L4K 4M5
DISTRIBUTED IN AUSTRALIA BY (DISTRIBUÉE EN
AUSTRALIE PAR/
DISTRIBUIDO EN AUSTRALIA POR) TOYS“R”US
(AUSTRALIA (AUSTRALIE)) PTY LTD.(LTÉE), REGENTS
PARK NSW 2143
IMPORTED BY (IMPORTÉ PAR/IMPORTADO EM)
O.I. NO. 6120
AD12504
CAUTION-ELECTRIC TOY:
Not recommended for children under 8 years of age.
As with all electric products, precautions should be
observed during handling and use to prevent
electric shock.
CAUTION- SUPERVISION REQUIRED-ELECTRIC
  TOY-UNPLUG WHEN NOT IN USE.
PERFORMANCE TIPS FOR VEHICLE
•  Do not drive car on grass, sand or carpet.
•   Do not drive car through water.
•  Be sure to rest your vehicle for at least 30 minutes after
  every 15 minutes of operation.
•   Make sure ON/OFF switch on your vehicle is in the “OFF” 
  position when it is not in use.
•   Do not bend the antenna.
•   Electrical, CB interference, mobile phones, air conditioning, 
  elevators and steel girders in buildings will affect the 
  operation of your vehicle.
•   Do not leave the vehicle or transmitter near sources of heat 
  or in direct sunlight for long periods of time.
•   Remove the batteries from the vehicle and transmitter when 
  they are not in use.
TRY ME UNIT:
Try Me button box is for demonstration 
purpose only. Dispose of this unit by 
detaching the wires connecting to the 
car before playing.
TRY ME
UNIT
OPERATING INSTRUCTIONS:
BATTERY PACK CARE / CAUTIONS:
1.  If battery pack and/or connectors are wet, thoroughly 
  
dry  before  charging.
2.  Unplug the battery pack if it is not going to be used 
  
for  several  days.
3.  Do not charge battery pack that is hot, wet or shows 
   signs of leakage or corrosion.
4.  Do not expose to fire, as explosion may result.
5.  Do not disassemble the battery pack. 
6.  Rechargeable battery pack is only to be charged 
   
by  adults.
BATTERY INSTALLATION:
IMPORTANT: FOR MAXIMUM PERFORMANCE,
YOU MUST FULLY CHARGE BATTERY PACK
BEFORE FIRST TIME USE.
THE RECHARGEABLE NI-MH BATTERY PACK IS 
NOT CHARGED.  PLEASE CHARGE IT FOR 3 
HOURS PRIOR TO USE.
1.  Plug the wall pack battery charger into wall outlet. 
   (See Diagram 1) 
2.  Click the battery pack into the charger. Make certain 
   the battery pack is secure in charger. 
3.  To disconnect, push the button of the charger 
   (See Diagram 1) and simultaneously slide battery 
  
pack  out. 
4.  Allow about 3 hours full-charge.  The red light indicator 
   keeps light up continuously when charging is in 
  
process.
5.  The charging is complete when the red light keeps 
  
flashing.  Then unplug the charger and pull apart 
  
the  battery  connectors.
6.  After charging for about 3 hours, the battery will be 
  
warm.  This condition is normal for fully charged 
  
batteries.
7.  If the speed of the car slows down suddenly, it is time 
  
to  recharge.
8.  After use, the battery pack will be hot! Wait at least 
  
20 minutes until it cools before recharging. 
  
Recharging a warm or hot battery pack will greatly 
  
shorten the battery life.
STORM
STORM
 CRUSHER
 CRUSHER
STORM
STORM
 CRUSHER
 CRUSHER
STORM
 CRUSHER
STORM
 CRUSHER
TM
This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, 
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly 
approved by the party responsible for compliance could void 
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause 
harmful interference to radio communications.
However, there is no guarantee that interference will not occur 
in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more 
of the following measures:
• Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from 
  that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician 
 for 
help.
FORWARD RUNNING
6. Push both the Driving Control Sticks forward
   for forward running. (See Diagram 6)
REVERSE RUNNING
7. Pull both the Driving Control Sticks backward
   for reverse running. (See Diagram 7)
TRANSMITTER:
1. Unscrew to open the battery cover at the
   back and install a 9V battery by matching
   the + and – signs as indicated in the
   battery compartment. (See Diagram 4)
2. Replace the battery cover and tighten the 
   screw to secure the battery cover.
(DIAGRAM 2)
(DIAGRAM 3)
(DIAGRAM 4)
(DIAGRAM 5)
(DIAGRAM 1)
9.6V Ni-MH
RECHARGEABLE
 BATTERY PACK
UNSCREW
OPEN
BATTERY
CHARGER
9.6V Ni-MH
 BATTERY
PACK
WALL OUTLET
PRESS BUTTON ON
SIDE OF CHARGER
TO RELEASE 
BATTERY PACK
LED INDICATOR
HOW TO PLAY
START TO PLAY
PAIRING TRANSMITTER WITH VEHICLE
1. Turn ON the vehicle (See Diagram 5).
2. Install a 9V battery in the transmitter, the 
   pairing LED light on the transmitter will flash 
3.  If pairing is successful, the pairing LED light 
   will  turn  OFF.
4. You must pair the transmitter with the 
   vehicle within 45 seconds, after 45 seconds 
   you must push the control on the transmitter 
   to  pair  again.
5. You must repeat pairing again whenever 
   replacing the transmitter’s battery.
VEHICLE:
1.  Make sure the “ON/OFF” switch at the
  
underside of the vehicle is at the “OFF”
  
position. (See Diagram 2)
2.  Unscrew to open the battery cover.
  
(See  Diagram  2)
3.  Insert the 9.6V Ni-MH battery pack into
  
battery compartment. (See Diagram 3)
4.  Replace the battery cover and tighten the
  
screw to secure the battery cover.
STOP OPERATION
12. Release both Driving Control Sticks, the
  
vehicle will Stop. (See Diagram 12)
STEERING OPERATION
8. Push only the Left Driving Control Stick
   forward to turn Right. (See Diagram 8)
9. Push only the Right Driving Control Stick
   forward to turn Left. (See Diagram 9)
360 DEGREE SPINS
10.Push the Left Driving Control Stick forward
  
while pulling the Right Driving Control Stick
  
backward at the same time. (See Diagram 10)
11. Push the Right Driving Control Stick forward
  
while pulling the Left Driving Control Stick
  
backward at the same time. (See Diagram 11)
IMPORTANT
If you experience any problems or issues with this item,
do not take it back to the store where you purchased. 
Please email service@scientific.com.hk and we will be 
happy to assist you in resolving any issues you may have. 
We thank you for your purchase.
(DIAGRAM 10)
(DIAGRAM 11)
(DIAGRAM 8)
(DIAGRAM 9)
(DIAGRAM 6)
(DIAGRAM 7)
(DIAGRAM 12)
ATTENTION PARENTS:
IT IS RECOMMENDED THAT THIS TOY AND
ALL ACCESSORIES BE PERIODICALLY
EXAMINED FOR POTENTIAL HAZARDS AND 
THAT ANY POTENTIALLY HAZARDOUS PARTS
BE REPAIRED OR REPLACED.
CAUTION-ELECTRIC TOY:
Not recommended for children under 8 years of
age. As with all electric products, precautions
should be observed during handling and use to
prevent electric shock.
CAUTION-SUPERVISION
REQUIRED-ELECTRIC TOY-
UNPLUG WHEN NOT IN USE.
INPUT: 120V AC, 60HZ, 300mA
OUTPUT: 12V DC, 500mA
DRIVING CONTROL
STICK
DRIVING CONTROL
STICK
FORWARD
RIGHT
LEFT
FORWARD
BACKWARD
BACKWARD
RIGHT
LEFT
FORWARD
FORWARD
DRIVING CONTROL
STICK
DRIVING CONTROL
STICK
FORWARD
FORWARD
FORWARD
BACKWARD
BACKWARD
REVERSE
DRIVING CONTROL
STICK
DRIVING CONTROL
STICK
INPUT: 120V AC, 60Hz, 300mA
FAST LANE IS A MARK OF (EST UNE MARQUE DE/
ES UNA MARCA DE) GEOFFREY, LLC, A SUBSIDIARY OF
(UNE FILIALE DE/UNA SUBSIDIARIA DE) TOYS“R”US, INC.
© 2017 GEOFFREY, LLC
MADE IN CHINA (FABRIQUÉE EN CHINE/FABRICADO EN
CHINA)
AUX ÉTATS-UNIS PAR/DISTRIBUIDO EN LOS ESTADOS
UNIDOS POR)
DISTRIBUTED IN THE UNITED STATES BY (DISTRIBUÉE
www.toysrus.com
www.toysrus.ca
CONFORMS TO THE SAFETY
REQUIREMENTS OF ASTM F963.
Contents and colors may vary.
Batteries are demonstration purposes only.
They should be replaced upon purchase for
optimal performance.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc),
or rechargeable batteries.
8