Tait International Limited TBCH1A ユーザーズマニュアル

TB9400 Installation and Operation Manual

© Tait Limited April 2014

The display is used in conjunction with the keypad to access the base 
station’s menus. It allows the technician to configure the IP address of each 
reciter (refer to 

), and to set the contrast 

of the display (see below).

After the base station is powered up, the display shows “Please wait...” 
while the base station is starting up, followed by the home screen when the 
start-up process is complete. The home screen shows four lines of user-
defined text, which can be entered via the web interface (Identity > Identity 
> Base Station Identity). 

From the home screen press an arrow key, a scroll key or OK to go to the 
base station menu. The display returns to the home screen from any other 
screen 30 seconds after the last key press. Press any key to turn on the 
backlight. The backlight turns off 30 seconds after the last key press. 

If the keypad has been disabled, pressing an arrow key, a scroll key or 
OK will cause the display to show “Keypad Disabled”.

Set the display contrast as follows:

1.

From the base station menu select Modules > Front Panel > Contrast.

2.

To increase the contrast, press the right arrow or scroll up key. To 
decrease the contrast, press the left arrow or scroll down key.

3.

When the contrast is set to the required level, press OK to save the 
changes and exit the menu.

i