Tait International Limited TBCH1A ユーザーズマニュアル

TB9400 Installation and Operation Manual

© Tait Limited April 2014

8.

Select the User configured option, and then enter a number that is on 
the same subnet as the base station. For example, if the TB9400 has 
IP 192.168.1.2, enter 192.168.1.1 for the PC. 

9.

Enter a suitable subnet mask, for example 255.255.255.0.
The web browser should now be able to connect to any physically 
connected base station that is on the same subnet.

10.

Once the web browser session is finished, re-connect the local area 
network cable to the PC. The PC then uses its normal TCP/IP 
properties. 

1.

Remove the local area Ethernet connection and connect an Ethernet 
patch cable between the PC and the base station. You can use either 
a straight through or crossover Ethernet patch cable with the current 
base station firmware.

2.

Select Start > Settings > Network and Dialup Connections.

3.

Double-click the Local Area Connection icon.

4.

Click Properties. 

5.

Click Internet Protocol (TCP/IP), and then click Properties.

6.

Note the current settings so that you can restore them later.

7.

Select Use the following IP address, and then enter a number that 
is on the same subnet as the base station. For example, if the base 
station has IP 192.168.1.2, enter 192.168.1.1 for the PC. 

8.

Enter a suitable subnet mask, for example 255.255.255.0.
The web browser should now be able to connect to the base station.

9.

When you have finished the web browser session, re-connect the 
local area network cable to the PC and then restore the original PC 
configuration. When you close the Network connection dialog box, 
the restored configuration is applied.