Tait Limited TEL0064 ユーザーズマニュアル

Copyright TEL

If you have any questions about this manual or the equipment it describes, please con-
tact your nearest Tait Dealer or Customer Service Organisation. If necessary, you can get
additional technical help from Customer Support, Tait Electronics Ltd, Christchurch,
New Zealand (full contact details are on page 2).

When requesting information, please quote either the manual product code (e.g.
M830P-00-1TA), or the equipment product code and serial number which are printed on
a label on the back of the product (as shown in 

If you require information about a particular PCB, please quote the full PCB internal
part number (IPN) which is screen printed onto the top side of the board (refer to the
appropriate PCB Information section in this manual for more details).

This equipment contains CMOS Devices which are susceptible to damage from static
charges. Care when handling these devices is essential. For correct handling procedures
refer to the manufacturers' data books, e.g. Philips data books covering CMOS devices,
or Motorola CMOS data books, Section 5 'Handling', etc.

An anti-static bench kit (refer to 

) is available from Tait Electronics Ltd under

the following product codes:

• KS0001 - 1 conductive rubber bench mat

- 1 earth lead to connect the mat to ground

• KS0004 -  1  wrist  strap.

this area used for regional
Type Approval information

product code

serial number

T835-10-0000

Rev 1

900000

Tait Electronics Limited
Made in New Zealand

T838-10-0000

Rev 1

900000

Tait Electronics Limited
Made in New Zealand