Johnson Controls Interiors L.L.C. R171HL3 ユーザーズマニュアル
Page 4 of 4
3.
Firmly press and release the programmed HomeLink button. Press and release the HomeLink button a second
time to complete the training process. (Some garage door openers may require you to do this procedure a third
time to complete the training.)
time to complete the training process. (Some garage door openers may require you to do this procedure a third
time to complete the training.)
The garage door opener should now recognize the HomeLink signal and activate when the HomeLink button is
pressed. The remaining two buttons may now be programmed if this has not previously been done. Refer to the
“Programming” portion of this text.
pressed. The remaining two buttons may now be programmed if this has not previously been done. Refer to the
“Programming” portion of this text.
Erasing Programmed HomeLink
®
Buttons
Individual buttons cannot be erased, however, to erase the three programmed buttons:
1.
Press and hold the two outside buttons until the indicator light beings to flash
after 20 seconds.
after 20 seconds.
2.
Release both buttons.
The HomeLink Universal Transceiver is now in the train (or learning) mode and can be programmed at any time
following steps 2 through 4 in the “Programming” portion of this text.
following steps 2 through 4 in the “Programming” portion of this text.
Reprogramming a Single HomeLink
®
Button
To program a device to HomeLink using a button previously trained, follow these steps:
1.
Press and hold the desired HomeLink button. Do NOT release until step 4
has been completed.
has been completed.
2.
When the indicator light begins to flash slowly (after 20 seconds), position
the hand-held transmitter 1 to 3 inches away from the HomeLink surface.
the hand-held transmitter 1 to 3 inches away from the HomeLink surface.
3.
Press and hold the hand-held transmitter button.
4.
The HomeLink indicator light will flash, first slowly and then rapidly. When
the indicator light begins to flash rapidly, release both buttons.
the indicator light begins to flash rapidly, release both buttons.
The previous device has now been erased and the new device can be activated by pushing the HomeLink button that
has just been programmed. This procedure will not affect any other programmed HomeLink buttons.
has just been programmed. This procedure will not affect any other programmed HomeLink buttons.
This device complies with Part 15 of the FCC rules and with RSS-210 of the Industry Canada. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation.
WARNING: The transmitter has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the device.
may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation.
WARNING: The transmitter has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the device.
HomeLink
®
is a registered trademark owned by Johnson Controls, Inc.