Digital Monitoring Products Inc PC0181 ユーザーズマニュアル
XTLplus Installation and Programming Guide
Digital Monitoring Products
9
PROGRAMMING INTRODUCTION
If the panel does not acquire the keypad by the end of the 10 minute pairing timer, the keypad displays
Pairing Failed, followed by the Reset screen. See Figure 8 and Figure 9. Reset your panel and tap the Pair
button to restart the pairing process.
If the keypad loses communication with the panel, the No Communication With System display appears and
If the keypad loses communication with the panel, the No Communication With System display appears and
provides the option to reattempt pairing. See Figure 10.
Wireless Keypad Association
To enable wireless keypad association operation on a LCD Wireless keypad, press and hold the Back Arrow
To enable wireless keypad association operation on a LCD Wireless keypad, press and hold the Back Arrow
key and CMD until SET BRIGHTNESS displays. Enter the code 3577 (INST) and press CMD. Press KPD RF to start
the RF survey communication. The keypad displays its wireless serial number and RF SURVEY.
To enable association operation on a Wireless Graphics Touchscreen keypad, access the Options menu
To enable association operation on a Wireless Graphics Touchscreen keypad, access the Options menu
through the carousel menu. While in the Options display, press the Installer Options icon. Enter the code
3577 (INST) and press CMD. Press KPD RF to start the RF survey communication. The keypad displays its
wireless serial number and RF SURVEY.
The keypad Power/Armed LED turns Red, indicating communication has not yet been established with the
The keypad Power/Armed LED turns Red, indicating communication has not yet been established with the
panel receiver.
To enable association operation in the XTLplus Series panel, press the XTLplus
To enable association operation in the XTLplus Series panel, press the XTLplus
Series RESET button three times allowing the wireless TRANSMIT LED (TX)
located near the top of the PCB to begin flashing between each press. When
in keypad association, the XTLplus Series Red and Green logo LEDs turn on
steady.
For 60 seconds, the panel listens for wireless keypads that are in RF Survey
For 60 seconds, the panel listens for wireless keypads that are in RF Survey
and have not been programmed, or associated into another panel. Wireless
keypads are assigned to the first open device position in Device Setup
automatically, based upon the order in which they are detected. When
successful communication has been established, the Power/Armed LED turns
Blue on Graphics keypads or Green on LCD keypads.
Note: A maximum of four wireless keypads are allowed on each panel.
See the 9000 Series Wireless Keypad Installation Guide (LT-1107) or 9862
Note: A maximum of four wireless keypads are allowed on each panel.
See the 9000 Series Wireless Keypad Installation Guide (LT-1107) or 9862
Graphic Touchscreen Wireless Keypad Installation Guide (LT-1367) for
additional information.
RESET
LOAD
XTL PLUS
B
AT
PROG
R B
+ DC -
S
N
LEV
LPC-0181
R1
INSTALL GUIDE
LT-1434
LT-1434
CELL
MODULE
©
2015 DMP
WWW.DMP.COM
Red LED
Green LED
Green
Transmit
LED
Yellow
Receive
LED
WiFi
LED
TAMPER
Button
Figure 11: XTLplus Backlit
Logo LED’s
TODAY
WEDNESDAY
82
98 77
HI LO
CURRENT
98 77
HI LO
Reset your
System.
Press button:
PAIR
2
1
Figure 9: Auto Pairing Reset Display
TODAY
WEDNESDAY
82
98 77
HI LO
CURRENT
98 77
HI LO
?
No Communication With System
Press To Pair With System
!
Figure 10: Auto Pairing No Communication Display