Digital Monitoring Products Inc PC0181 ユーザーズマニュアル
Digital Monitoring Products
XTLplus Installation and Programming Guide
20
MESSAGING SETUP
24.2
Enable Messaging
Select YES to allow the panel to send messages to three programmed destinations.
Default is NO.
24.3
System Name
Enter a unique name for the panel. The panel name is used as the sender of the
message. The text entered is displayed with initial caps. If this field is left blank,
the panel account number is sent.
24.4
Destination 1
Enter the first cell phone number where text messages will be sent. The message can
be sent to any device (computer or cell phone) as long as a valid cell phone number
is entered.
24.5
Destination 1 User Number
Enter a valid, previously-programmed user number. This option is used when sending
commands such as arming or disarming back to the pan el using MyAccess™ SMS Text from
the same cell phone. The user number must have the authority to perform the commands
as if it occurred at the keypad. Entering 0 (zero) disables this option. Default is 0.
24.6
Destination 2
Enter the second destination cell phone number.
24.7
Destination 2 User Number
Enter a valid User Number for arming/disarming authorization.
24.8
Destination 3
Enter the third destination cell phone number.
24.9
Destination 3 User Number
Enter a valid User Number for arming/disarming authorization.
24.10
O/C SMS
Select YES to allow the panel to send Opening and Closing messages to a cell phone
via SMS protocol. Default is NO. This option appears only if any destination above is
a cell phone number.
24.11
Monthly Limit
This option displays if any programmed destination is a cell phone number using
CELL communication. This number limits the monthly incoming and outgoing SMS
messages allowed to be sent or received by the panel.
A panel event that causes messages to be sent to destination cell phone numbers
is counted towards the panel’s monthly limit. For example, if an alarm message
is sent to a cell phone number, a total of 2 messages are counted towards the
monthly limit for the panel. SMS messages sent from a cell phone to the panel,
including status requests and MyAccess™ SMS Text messaging commands, also
count toward the monthly limit. The limit is reset at midnight on the 14th of every
month. Range is from 0 to 999. When 0 is entered, there is no limit on the number
of messages able to be sent or received by the panel. Default is 0.
Note: The SecureCom Wireless text plan selected for the panel should match or
exceed the programmed Monthly Limit.
Device Setup
25.1
Device Setup
This section allows you to define the XTLplus panel wireless keypad configuration.
You can install and address up to four wireless keypads.
25.2
Device Number
Enter the device number of the wireless keypad you are programming. The valid
range is 2-5.
Note: Address one is reserved for the XTLplus programming keypad attached
during programming. After you program each option for the first keypad, repeat
these programming steps for each additional keypad.
ENABLE MESSAGING
NO YES
NO YES
SYSTEM NAME
-
-
DESTINATION 1
-
-
DESTINATION 1
USER NUMBER: 0
USER NUMBER: 0
DESTINATION 2
-
-
DESTINATION 2
USER NUMBER:
USER NUMBER:
0
DESTINATION 3
DESTINATION 3
USER NUMBER:
USER NUMBER:
0
O/C SMS NO YES
MONTHLY LIMIT: 0
DEVICE SETUP
DEVICE NO:-
DEVICE SETUP