Communications Specialists Inc PT-1 ユーザーズマニュアル
PT-1 PET TRANSMITTER
Introduction
The Communications Specialists Model PT-1 pet transmitter attaches to your pet's
collar so it can be found if lost. The transmitter is programmed to operate on one of 50
channels so multiple pets in a single household or neighborhood can operate at the same
time without interference to each other. The channel number of the transmitter is shown
on the sticker on the PT-1 case. It weighs less than 1/2 ounce including the battery which
allows it to be used with the smallest of pets. The battery will power the PT-1 for
approximately 6 weeks.
Installation
channels so multiple pets in a single household or neighborhood can operate at the same
time without interference to each other. The channel number of the transmitter is shown
on the sticker on the PT-1 case. It weighs less than 1/2 ounce including the battery which
allows it to be used with the smallest of pets. The battery will power the PT-1 for
approximately 6 weeks.
Installation
Remove the collar from around your pet's neck and punch a small hole in it with a
sharp nail or icepick. Unscrew the small nut holding on the antenna from the threaded
shaft on the back of the PT-1. Push the threaded shaft through the hole previously
punched in the collar. Reinstall the antenna on the threaded shaft and secure it with the
removed nut. Tighten down the nut so the PT-1 and antenna do not twist and are securely
attached to the collar. The PT-1 should be on the outside of the collar and the antenna
should be laying parallel against it.
shaft on the back of the PT-1. Push the threaded shaft through the hole previously
punched in the collar. Reinstall the antenna on the threaded shaft and secure it with the
removed nut. Tighten down the nut so the PT-1 and antenna do not twist and are securely
attached to the collar. The PT-1 should be on the outside of the collar and the antenna
should be laying parallel against it.