Westell Inc. 7502AGXX-00 ユーザーズマニュアル
030-300589 Rev. A
34
March 2009
User Guide
Control Point Home Monitoring Service
8. ACCESSING YOUR CONTROL POINT USER INTERFACE
IMPORTANT: The following sections assume that your Internet network is up and functioning properly, that your
7502AG Control Point and 7521FF Camera devices are installed, and that you have QuickTime installed.
Now that you have activated your Control Point, you are ready to customize the configurable features of your
service, such as Camera and Media settings, Sensors, Schedules, etc. Control Point provides a User Interface that
allows you to access these features and customize them to your preference.
To access the Control Point User Interface, start your browser and type the following IP address in the browser’s
address bar:
http://192.168.1.16
Then, press Enter on your keyboard. The Control Point User Interface should appear in your browser.
Control Point User Interface
Navigating the Control Point User Interface
The Control Point User Interface displays a main navigation menu at the top of each page, allowing you to navigate
to the various pages of your Control Point service. Clicking the sub-menu tabs—located below the main menu
options—allows you to access specific services within the main menu.
NOTE: If you are at a page and need help, click the Help link in the upper-right corner of the screen to learn more
about that page.
Resetting the Control Point to Factory Defaults
If you decide to reset your Control Point to its factory default settings, simply press the Reset button on the back of the
unit for more than 10 seconds, and then wait for the Control Point to reset. Alternatively, you can reset the Control Point
to factory defaults by clicking the System tab within the Config menu, as explained later in this User Guide. Resetting the
Control Point to factory defaults may be useful for recovering from situations where the device is performing abnormally.
NOTE: If you reset the Control Point to factory default settings, you will need to sign in to your Control Point again
to access the User Interface. If needed, refer to section 7.2 for details on signing in to your Control Point.
The following sections provide details on configuring your Control Point services. From this point forward the
7502AG will be referred to as the “Control Point.” And the 7521FF Camera will be referred to as the “Camera.”
The Control Point User Interface displays a main navigation menu at the top of each page, allowing you to navigate
to the various pages of your Control Point service. Clicking the sub-menu tabs—located below the main menu
options—allows you to access specific services within the main menu.
NOTE: If you are at a page and need help, click the Help link in the upper-right corner of the screen to learn more
about that page.
Resetting the Control Point to Factory Defaults
If you decide to reset your Control Point to its factory default settings, simply press the Reset button on the back of the
unit for more than 10 seconds, and then wait for the Control Point to reset. Alternatively, you can reset the Control Point
to factory defaults by clicking the System tab within the Config menu, as explained later in this User Guide. Resetting the
Control Point to factory defaults may be useful for recovering from situations where the device is performing abnormally.
NOTE: If you reset the Control Point to factory default settings, you will need to sign in to your Control Point again
to access the User Interface. If needed, refer to section 7.2 for details on signing in to your Control Point.
The following sections provide details on configuring your Control Point services. From this point forward the
7502AG will be referred to as the “Control Point.” And the 7521FF Camera will be referred to as the “Camera.”
Main
navigation
menu
Submenu
tabs