Westell Inc. A9081XXYY-07 ユーザーズマニュアル

 

 

 

 

 

030-300479 Rev. A 

14 

October 2005 

 User Guide 

 

To browse the Internet using your UltraLine IIB, you must confirm your DSL sync, set up your account profile, and 
establish a PPP session with your Internet service provider (ISP). 
 
NOTE: Internet service provider subscriber software and connection requirements may vary. Refer to the Internet 
service provider’s installation manual to install the software required for your Internet connection.  
 

 
After connecting the hardware for the UltraLine IIB, start your Internet browser and type http://192.168.1.1/ in the 
browser’s address bar. Next, press ‘Enter’ on your keyboard. The following Connection Overview screen will be 
displayed.  
 
You must have active DSL service before the UltraLine IIB can synchronize with your ISP’s equipment. To determine if 
the Gateway has a DSL sync, view the DSL Connection Rate at the Connection Overview field. If the status reads No 
DSL Connection, check the DSL physical connection, explained in section 6 (INSTALLING THE HARDWARE) of 
this User Guide. The following screen shows the DSL connection rate with values that indicate a successful DSL SYNC 
has been established. The connection rate values represent the transmission speed of your DSL line. (The Gateway may 
take time to report these values.)  
 
NOTE: If no DSL sync is established, the Connection button will not be displayed in the Connection Overview 
screen. To determine if the DSL sync is established, check the Gateway’s DSL LED. If the DSL LED is not solid 
green, you do not have a DSL sync established. Contact your Internet service provider for further instructions. The 
Gateway will handle transmission rates up to 8 Mbps. Your actual DSL rates may vary depending on your Internet 
service provider.