Westell Inc. AR210 ユーザーズマニュアル
SuperVision® System Manual
CAP Rate-Adaptive Ethernet DSL Remote Unit
A90-36R210W00
Part # 030-1010xx
A90
Rev.
P2
, 07/01/98
1998, Westell, Inc
.
Release 1.2
Printed in the USA
10BT-R.DOC
7
READY
State
Description
Slow Flashing Green
Power ON and passed power-up diagnostics (1 flash/sec)
Moderate Flashing Green
Power ON and attempting synchronization (2 flashes/sec)
Fast Flashing Green
Power is ON and synchronized with the ATU-C and downloading
operational sequence (4 flashes/sec)
operational sequence (4 flashes/sec)
Steady Green
Power ON and synchronized with ATU-C
Steady Green/
Intermittent Red
Power is ON and synchronized with ATU-C, but a line error
condition was detected
condition was detected
Steady Red
Unit diagnostic failed
Blinking Red
Unit failed power-up diagnostic
No Light
No power
LINK
State
Description
Steady Green
Link established
No Light
No 10BaseT link
ACTIVITY
State
Description
Pulsing Yellow
Traffic is being transmitted. Pulses should match the receipt or
transmit of Ethernet data
transmit of Ethernet data
No Light
No traffic
6.5 Interfaces and Connectors
On the rear panel, the ATU-R has a power ON/OFF switch, connectors for power,
POTS/DSL, a phone and customer terminal equipment port.
POTS/DSL, a phone and customer terminal equipment port.
Figure 2
shows the ATU-R’s
side panel.
Connectors
N
AME
T
YPE
U
SE
Power
MINI-DIN connector
Power
Line
one 8-pin modular jack
POTS/DSL
Phone
6-pin modular jack RJ11
POTS
Ethernet
8-pin RJ45 jack
Ethernet (customer terminal equipment option)
Figure 2
shows the connector side of the ATU-R with the optional phone connector shown.
Figure 3
shows the side panel without POTS splitter. The phone jack is not provided on the
unit without internal POTS.