Westell Inc. B755 ユーザーズマニュアル

 

 

 

 

 

030-300629 Rev. A 

91 

     February 2011 

 
NOTE:

 The instructions in this section refer to the Router configured for Ethernet WAN Uplink port mode. Be sure 

that you have selected WAN Uplink port in the VersaPort screen. 

 

 
14.2.3.3.1  Configuring the WAN Uplink Protocol Settings for PPPoE 

 

After you have selected WAN Uplink port, in the preceding steps, select the desired protocol from the  Protocol 

drop-down menu. If you select PPPoE, the following screen will appear. Select the desired options, and then click 
Apply

 to save the settings. 

 
NOTE:

  

1. If you experience any problems, reset the Router by pressing the reset button on the rear of the Router. Or follow 

the instructions in section 16.2, “Restore Defaults,” to restore the Router to factory default settings. The actual 

information displayed in this screen may vary, depending on network connection established. 

 

2. PPPoE is the factory default setting for WAN Uplink port. 

 

 

 

 

 

Tunneling 

Factory Default = Enable 

If Enabled, this option allows PPP traffic to be bridged to the WAN. This feature 

allows you to use a PPPoE shim on the host computer to connect to the Internet 

Service Provider, by bypassing the Router’s capability to do this. Factory default is 

“Enable.” 

Secondary WAN 

Factory Default = Disable 

The secondary WAN interface is used for multicast traffic. This feature applies only 

when you are using PPPoE as the Primary WAN protocol. 

Proxy ARP 

Factory Default = Disable 

When this feature is activated, the VersaLink will respond to ARP requests. 

To activate this feature, click Enable.