PRÜFTECHNIK Condition Monitoring GmbH VCRFBR24 ユーザーズマニュアル
44
VIBCONNECT RF 05.2012
1B-8F-DC-4C-00-36
1B-8F-DC-4C-00-38
5.4.3 Mounting sensor unit
CAUTION
Risk of injury from rotating machine parts!
When installing the sensor unit while the machine is running,
there is a risk of serious injury caused by exposed, moving machine
parts.
When installing the sensor unit while the machine is running,
there is a risk of serious injury caused by exposed, moving machine
parts.
» Do not remove any guards on the machine.
» Always adhere to the safety instructions for work on running
machinery.
• Install the sensor unit at the location with the best possible radio
reception.
• Drill two mounting holes. For the drill pattern, refer to the fixing
tabs on the housing in the dimensional drawing in chapter 3
“Technical data”.
“Technical data”.
• Secure the sensor unit with two bolts to the machine.
Note
It is also possible to use one sensor unit to monitor two separate
machines of a machine train, for example in cases where only the
bearing at the coupling side of the motor and the pump are to be
monitored. It is, however, not possible to monitor two separate
machine trains with a single sensor unit.
It is also possible to use one sensor unit to monitor two separate
machines of a machine train, for example in cases where only the
bearing at the coupling side of the motor and the pump are to be
monitored. It is, however, not possible to monitor two separate
machine trains with a single sensor unit.
• Document the location of installation of the sensor unit in the
measurement location report: Each sensor unit is supplied with
an adhesive label on which the MAC address of the sensor unit
is printed. Remove this label and stick it to the measurement
location report beside the name of the respective machine or
machine train.
an adhesive label on which the MAC address of the sensor unit
is printed. Remove this label and stick it to the measurement
location report beside the name of the respective machine or
machine train.
Installation and commissioning
Adhere the MAC address
of the sensor unit on the
measurement location
report.
of the sensor unit on the
measurement location
report.