Rhine Electronics Co Ltd 7096T ユーザーズマニュアル

ページ / 2
1/1 
 
INSTRUCTIONS FOR OPERATION 
 
 
 
UC7096T :  SETING THE OPERATING CONTROLS 
 
1.This unit operates on  AAA 1.5 volts battery*4 (not included).(We use AAA battery*4) 
   To prevent possible damage if the battery should leak , be sure to remove 
   the battery when the unit is not use . 
 
2. Store the controller away from excess heat or humidity . 
 
3. This remote control unit is required with 16 code combinations. To prevent 
 possible interference from or to other remote units such as garage door 
 openers, car alarm or security system .  If you find that your fan and light  
 kit go on and off without using your control , simply change the combination 
 code in your transmitter and receiver . 
 
4.Operation buttons on the panel of transmitter . 
FAN(
D
)    key – For fan speed  control 
甲、  HIàMEDàLOWàOFFà Cycle Operation  
FAN AUTO  key – Auto temp. set-up à manual à cycle set-up
  
甲、  Temp. of indoor is lower than set-up temp.      
OFF 
乙、  Temp. of indoor is lower than set-up temp. 
0~2℃       
LOW  
SPEED 
丙、  Temp. of indoor is lower than set-up temp. 
2℃或 4℉   
MED  
SPEED 
丁、  Temp. of indoor is lower than set-up temp.    4℃或 8℉   
HI  
SPEED  
 
TIMER key –  Set timer option of FAN  OR  LIGHT 
HOUR ▲   key – Have time or temp. up. 
HOUR ▼   key – Have time or temp. down. 
FAN/REV  key – Fan reverse control  
LIGHT(
@
)   key – For light brightness and ON/OFF control . 
LIGHT DELAY key – Auto off after 3 mins. 
 
5.Start the fan and Turn off the fan: 
Press the selected speed button to run the fan at the desired . 
 
6.Light control : 
Turn the light on or off by only touching the LIGHT CONTROL  button . 
Keep pressing the button in excess of  0.7 second it becomes a dimmer , 
the light varies cyclically in  0.8 second .