Rhine Electronics Co Ltd 9058T ユーザーズマニュアル
INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
1. This device which one of black lines series with AC 120V power supply. Now, we take 60Hz power
supply to afford power supply of transmitter when it trough rectify. So, there is no troubles with
change batteries forever.
supply to afford power supply of transmitter when it trough rectify. So, there is no troubles with
change batteries forever.
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 32 code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
4. Operation buttons on the panel of transmitter .
key – For fan speed Reverse .
key – For light brightness and light ON/OFF control .
key – For fan speed control . fan 1 2 3 4 --> 4 3 2 1 speed cycle.
key – For light brightness and light ON/OFF control .
key – For fan speed control . fan 1 2 3 4 --> 4 3 2 1 speed cycle.
key – For FAN OFF control .
key – POWER SW , for POWER ON/OFF
key – POWER SW , for POWER ON/OFF
5. Fan control :
Turn the FAN on touching the button .
pressing the button , fan 1 2 3 4 --> 4 3 2 1 speed cycle.
Turn the FAN on touching the button .
pressing the button , fan 1 2 3 4 --> 4 3 2 1 speed cycle.
6. Fan reverse control :
Press the button Change the direction of the fan to run
Press the button Change the direction of the fan to run
7. Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
One of the important feature of this control is AUTO-RESUME . After power
on , it allows the light return to where it was off .
on , it allows the light return to where it was off .
8. Power switch
1/2 2013/10/8