Laird Controls North America Inc. 814A ユーザーズマニュアル
CommandPro
®
23 Series
User Manual
19
142133 Rev B
7 M
AINTENANCE AND
T
ROUBLESHOOTING
7.1 Monthly Inspection Schedule
Inspect the transmitter for damage to keypad and case.
Inspect all electrical and antenna connections to ensure they are clean and tight.
Ensure all terminal strips are firmly in place.
7.2 Transmitter Troubleshooting
The transmitters have an LED status indicator to aid in troubleshooting. Due to the rough treatment it may
be subjected to, most problems are likely to occur in the transmitter. Thoroughly diagnose the transmitter
before proceeding to the receiver.
WARNING: When testing the transmitter, the receiver may become active resulting in system
operation. Always assume the system is working and will respond when testing a transmitter.
AVERTISSEMENT: Lors d’essais de fonctionnement du transmetteur, le récepteur peut être active
et provoquer la mise en marche du système. Toujours considérer que le système fonctionne et
qu’il répondra aux essais du transmetteur.
Problem
Possible Cause
Remedy
LED is off.
Transmitter is off
Press ON/ALARM button.
Batteries are dead.
Replace batteries.
Transmitter failure.
Call for service.
LED cycles on/off (0.5 second on, 0.5
second off).
Batteries are low.
Change batteries at the next convenient
opportunity.
LED flashes red/green (‘A’ series
only).
Batteries are low.
Change batteries at the next convenient
opportunity.
LED is continuously on (LED might
flicker slightly).
Switch activated at start.
Restart transmitter with no other switches
pressed.
Transmitter failure.
Call for service.
7.3 Transmitter Repairs
CAUTION: The transmitter’s electronic components are exposed when the back of the case is
removed. Take caution to prevent dirt or other contaminants from entering the case. Do not
allow the circuit to be scraped or damaged in any way.
AVERTISSEMENT : Lorsque l’endos du boîtier est enlevé, les composants électroniques sont à
découvert. Prendre soin d’éviter de laisser la saleté ou tout autre contaminant entrer dans le
boîtier. Éviter d’érafler ou d’endommager le circuit de quelque façon que ce soit.
7.3.1 Battery Replacement
Remove the screws on the back of the transmitter and remove the back of the case.
1.
Remove and replace the AA alkaline batteries. Be sure to observe the correct polarity.
2.
Reassemble the transmitter in reverse order, making sure the battery wires do not get pinched
3.
between the case halves. Tighten the screws snugly.