Laird Controls North America Inc. U915 ユーザーズマニュアル
902-928MHz FSK version
Specific Requirements
Document p/n: 9S01-U915-A201, rev.2
Cattron-Theimeg Inc.
Proprietary and Confidential
2-1
2.
Overall Description
2.1.
Product Perspective
This Radio module version is constrained to 902-928MHz, 0dBm to 5dBm, FSK modulation and some
restriction on maximum duty cycle if secondary antennas are used.
restriction on maximum duty cycle if secondary antennas are used.
The Radio modules is to achieve full interchangeability between product model lines, maintaining mechanical
and software interfaces as well as physical dimensions is a general objective.
and software interfaces as well as physical dimensions is a general objective.
2.1.1.
User Interfaces
All interface between this module and the User will be software controlled by the product hosting this
module. Features such as Frequency, Power and Modulation are all controlled by the Host device.
module. Features such as Frequency, Power and Modulation are all controlled by the Host device.
2.1.2.
Hardware Interfaces
This product will have two hardware interfaces; these are the RF Port and a 50 pin I/O connector
carrying the microcontroller interface and power lines.
carrying the microcontroller interface and power lines.
The 50 pin interface will have a
•
4 wire serial interface, consisting of Clock in, Data out, Data in and Load.
•
Power: 3V3 and E2Prom 3-5V
•
I2C interface to store personality.
•
Data I/O 1 wire out 1 wire in
•
Chip enable 1 wire.
2.1.3.
Software Interfaces
This module will require the configuration of Data Registers by the operating firmware that set the
operating parameters.
operating parameters.
The AE system will provide the operational parameters to the operating firmware.
•
Frequency,
•
Power,
•
Tx/Rx Mode.
2.2.
Product Functions
•
The Product shall have the capacity to hold a permanent configuration file
•
The Product shall be software configurable
•
The Operating frequency shall be Programmable
•
The Modulation Deviation shall be programmable
•
The output power is programmable