Nagano Japan Radio Co . Ltd. NJT511 ユーザーズマニュアル
15
Adjusting the LCD Contrast & Beeper Volume
and Switching the Beeper & Vibrator
and Switching the Beeper & Vibrator
While holding down the M1 or M4 key (right-hand trigger switch), press the PW key,
and the following screen will appear on the LCD. This screen will disappear if no
keys are pressed for five seconds.
and the following screen will appear on the LCD. This screen will disappear if no
keys are pressed for five seconds.
When the beeper is selected
(default)
When the vibrator is selected
When both the beeper and
vibrator are selected
(The current selection is highlighted.)
Adjusting the LCD contrast
You can adjust the LCD brightness to eight contrast levels.
(1) Use the F5 and F6 keys to select the LCD CONTRAST line.
(2) To decrease the contrast, press the F7 key; to increase it, press the F8 key.
Switching the beeper & vibrator
You may choose any of three ways—beeping only, vibrating only, or beeping &
vibrating as a confirmation of completion of bar-code reading.
vibrating as a confirmation of completion of bar-code reading.
(1) Use the F5 and F6 keys to select the BEEPER VIBRATION line that will be
highlighted in any one of the following three states:
(2) Highlight the desired way(s) by using the F7 and F8 keys, referring to the above
figure.