Intermatic H0009 ユーザーズマニュアル

ページ / 3
-------------------------------------- DRAFT COPY --------------------------------------
Instructions for Model HA09 – Handy Remote Controller
<Front cover>
User’s Manual
*Illustration of HA09 controller*
 <Inside cover>
General Description
Federal Communications Commission Statement
This device complies with part 15 of the FCC rules. Operation of this device is subject to 
the following two conditions:  (1) This device may not cause harmful interference, and 
(2) This device must accept any interference, including interference that may cause 
undesired operation.
NOTE:  This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no guarantee that interference will not occur in 
a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following 
measures:
-- Reorient or relocate the receiving antenna or device.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
WARNING!
Changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment.
Enclosed you will find:
1 Handy Remote Controller
Installation Instructions
Remote Controller
1. Open the battery compartment located on the back of the remote controller by 
pressing down on the battery compartment tab and pulling the door outward.
2. Insert 4 “AAA” alkaline batteries (not included) with polarities as shown.
3. Replace the battery compartment by first inserting the 2 tabs at the bottom of the 
door, then pressing the door in until the door ‘clicks’ shut.